SDS

BFN NO/文件编号：1Li18650MP-1800mAh 版本 A1 Page 7 of 9
深 圳 市 博 富 能 电 池 有 限 公 司
SHENZHEN BOFUNENG BATTERY CO．，LTD
7 Safe Characteristic 安全性能
No. Item 项目 Test Methods and Condition 测试方法和条件 Criteria 标准
7.1
Over charge
testing
过充测试
At 23±5
℃
, charging cells with constant current 3C to
voltage 5.0V, then with constant voltage 5.0V till current
decline to 0. Stop test till cells temperature 10
℃
lower than
max temperature.
在 23±5℃状态下,电池用 3C 电流充电至 5.0V,然后恒压
5.0V 让电流下降接近为 0A,监视电池温度变化,当电池温
度下降一峰值低约 10℃时,停止实验.
No smoke or fire
不起火,不冒烟
7.2
Over discharge
testing
过放测试
At 23 ± 5
℃ ,
According to the requirements of standard
charge, the cells will be discharge to cut-off voltage, then
connect with external load of 30 ohm for 24 hours.
在 23±5℃状态下, 按标准放电的要求放电至终止电压
后,外接 30Ω负载放电 24 小时.
No fire, no smoke, no
leakage.
无起火,无冒烟,无泄
液
7.3
Short-circuit
testing
短路测试
At 23 ± 5 ℃ , After standard charging, connect cells
anode and cathode by wire which impedance less than 50m
Ω, keep 6h.
在 23±5℃状态下,标准充电后,将电池的正负极用一根
小于 50mΩ的导线连接,放置 6 小时.
No smoke or fire 不起
火,不冒烟
※ Above testing of safe characteristic must be with protective equipment.(
安全性能测试应在有保护措施下进行
)
8. CAUTIONS IN USE 使用警告
To ensure proper use of the battery please read the manual carefully before using it. Handling
为了使电池安全的使用及处理请在使用前认真的阅读操作说明

Do not expose to, dispose of the battery in fire.

不能把电池曝晒或丢在火中
 Do not put the battery in a charger or equipment with wrong terminals connected.

电池充电时不能把正负极性装反
 Avoid shorting the battery

避免短路电池
 Avoid excessive physical shock or vibration.

避免过分的物理震动和冲击电池

Do not disassemble or deform the battery.

不能拆解或使电池变形
 Do not immerse in water.

不能将电池浸入水中

Do not use the battery mixed with other different make, type, or model batteries.

不能将其它不同厂家，类型，型号的电池混合使用

Keep out of the reach of children.

禁止小孩接触电池
charge and discharge 充放电

Battery must be charged in appropriate charger only.

电池必须在合适的条件下充电