7264LED
Installation and Technical Information
BEGA
CSA certifi ed to U.S. and Canadian standards. Suitable
for wet locations.
In the interest of product improvement, BEGA reserves the right to make technical changes without notice.
© Copyright BEGA-US 2014
Garden bollard
Anchor bolts
(by others)
Supply wiring
Bollard wiring
Set screws
Anchor base
Supply wiring
Anchor base fl ange
Luminaire 7264LED:
Housings: Garden bollard housing made of aluminum alloy with matte
safety glass. Anchorage base made of hot-dip galvanized steel, made
for bolting onto foundation (by others) or other paved surfaces.
IMPORTANT: For use with magnetic landscape transformers ONLY.
Electrical: 3.4W LED luminaire, 5 total system watts, -30°C start
temperature. Integral 12V AC driver provided. Standard LED color
temperature is 3000K with an 85 CRI.
Warranty: 3 year manufacturer warranty
Notice to Installer for 7264LED:
WARNING: LEDs are high-quality electrical components. Please avoid
opening upper electrical compartment and do NOT touch LED module.
WARNING: RISK OF ELECTRIC SHOCK. Install all luminaires 10 feet
or more from pool, spa or fountain.
1. Compatible for use with 12-24V AC input voltage.
2. Voltage must NOT drop below 10V.
3. Turn main power OFF before start of installation.
4. Anchorage hardware provided by others.
5. Low voltage wiring is intended for shallow burial - no more than 6 in.
7264LED installation:
1. Loosen (2) set screws on garden bollard to remove anchor
base and anchor base fl ange.
2. Bring 12V-24V supply wiring into the bottom of the anchor base
and feed through to the top until there is 12” of cable coming up
through the top of the anchor base.
3. Fix anchor base to existing foundation or surface using suffi cient
anchor hardware, supplied by others.
4. Slide anchor base fl ange over anchor base so it covers the anchor
bolts.
5. Make wire splices from supply wiring coming out of anchor
base to bollard wiring coming down from bollard shaft. For
maximum wire run lengths, see table to the right.
6. Push splices into bollard shaft.
7. Mount bollard onto anchor base until the bottom of the
bollard hits the anchor base fl ange. Tighten (2) set screws to
secure bollard to anchorage shaft.
8. Connect supply wiring to main power. Turn main power on.
Garden luminaire - low voltage
7264LED
Tools Required:
3mm hex key
Standard small slotted screwdriver
Digging tool
Protection Class: IP64
Weight: 5.3 lbs.
Dimensions
A: 4 3/8”
B: 27 1/2“
Lamp: Integral 3.4W LED Module
(No replacement necessary)
7264LED
3/5/2014
18 16 14 12 10
40 46 73 116 185 294
30 61 97 155 246 392
20 92 146 232 369 588
15 122 195 309 492 784
10 183 292 464 738 1176
5 366 585 928 1477 2353
WireSize(AWG)
Max.RunLength(ft)PerWireSize:2Voltdrop
Connected
LEDWatts
Replacement Parts:
LED Module LED-0234/830
LED Driver 75946
Cable (6 ft.) 86067