User Manual

2) Specified with DC-zero mode applied to offset the non-zero residual

readings, if any

3) Add 10 LSD to the specified accuracy @ < 9 A

4) Maximum crest factor < 1.4:1 at full scale & < 2.8:1 at half scale

Frequency Hz

Function Sensitivity

(Sine rms) Range

600 V, 1000 V 50 V 5.00 Hz to 999.9 Hz

60 A (Precise low current) 40 A 40.00 Hz to 400.0 Hz

60 A, 600 A, 1000 A 40 A 40.00 Hz to 400.0 Hz

Accuracy: ± (1.0 % + 5 LSD)

DC-bias, if any, not more than 50% of Sine rms

& 3-Phase Rotation

measurement:

Voltage Range: 65 V to 600 V (sine wave only)

Frequency Range: 35 Hz to 400 Hz

measurement:

Voltage Range: 0.4 V to 600 V (sine wave only)

Frequency Range: 3 Hz to 400 Hz

Voltage Detection (NCV)

Typical Voltage Bar-graph Indication

20 V (tolerance: 10 V to 36 V) -

55 V (tolerance: 23 V to 83 V) - -

110 V (tolerance: 59 V to 165 V) - - -

220 V (tolerance: 124 V to 330 V) - - - -

440 V (tolerance: 250 V to 1000 V) - - - - -

Indication: bar-graph segments and audible beep tones proportional to the

field strength

Detection frequency: 50/60 Hz

Detection antenna: inside the top side of the stationary jaw

MAINTENANCE AND REPAIR

If the Meter fails to operate, check battery, test leads, etc., and replace as

necessary.

Double check the following:

1. Replace the fuse or battery if the meter does not work.

2. Review the operating instructions for possible mistakes in operating

procedure.