User Manual

21
Except for the replacement of the battery, repair of the meter should be
performed only by a Factory Authorized Service Center or by other qualified
instrument service personnel.
The front panel and case can be cleaned with a mild solution of detergent
and water. Apply sparingly with a soft cloth and allow to dry completely
before using. Do not use aromatic hydrocarbons, gasoline or chlorinated
solvents for cleaning.
BATTERY REPLACEMENT
When battery voltage drops below the value required for proper operation,
the battery symbol ( ) appears.
W Warning
To avoid shock, injury, or damage to the Meter, disconnect test leads before
opening case.
Replacing BATTERY follow below steps:
1. Disconnect the test lead probe from measuring circuit.
2. Turn the Meter to OFF position.
3. Remove the screws from the battery cover and open the battery cover
4. Remove the batteries and replace with 1.5V AA Size (IEC R6). Observe
correct polarity when installing the batteries.
5. Put the battery cover back and re-fasten the screw.
Battery: 2 x 1.5 V AA (IEC R6)