User Manual

CAT III

Overvoltage Category lll is for equipment intended to form

part of a building wiring installation. Such equipment includes

socket outlets, fuse panels, and some mains installation control

equipment.

Alternating Current (AC).

Direct Current (DC).

Battery.

Underwriters Laboratories. [Note: Canadian and US.]

Complies with European Directives.

Conforms to relevant Australian standards.

Do not dispose this product as unsorted municipal waste.

Contact aqualified recycler.

SAFETY INFORMATION

The Meter complies with:

• UL/IEC/EN 61010-1, CAN/CSA C22.2 No. 61010-1, Pollution Degree 2,

Measurement category IV 600 V and Measurement category III 1000 V

• IEC/EN 61010-2-033

• IEC/EN 61010-2-032

• IEC/EN 61010-031 (test leads)

• EMC IEC/EN 61326-1

Measurement Category IV (CAT IV) is for installed at or near the origin of

electrical supply to a building, between the building entrance and the main

distribution board. Such equipment may include electricity tariff meters and

primary over current protection devices.

Measurement Category III (CAT III) is for equipment intended to form part

of a building wiring installation. Such equipment includes socket outlets,

fuse panels, and some mains installation control equipment.

CENELEC Directives

The instruments conform to CENELEC Low-voltage directive 2006/95/EC and

Electromagnetic compatibility directive 2004/108/EC.

W

Warning: Read Before Using

To avoid possible electric shock or personal injury:

• Use the Meter only as specified in this manual or the protection

provided by the Meter might be impaired.

• Avoid working alone so assistance can be rendered.

• Never measure AC current while the test leads are inserted into the

input jacks.

• Do not use the Meter in wet or dirty environments.

• Do not use the Meter if it appears damaged. Inspect the Meter before

use. Look for cracks or missing plastic. Pay particular attention to the

insulation around the connectors.

• Inspect the test leads before use. Do not use them if insulation is

damaged or metal is exposed.