Datasheet

ManualsBrandsBeha-Amprobe ManualsCable Detectors / LocatorsReceiver

www.Beha-Amprobe.com

13310-engBeha-Amprobe

Insulation Stick attachment

A standard insulation stick can be attached to the AT-7000-

RE Receiver to easily trace wires in high ceilings, walls, and

along oors. The stick can be purchased from electrical

distributors.*

Insulation Stick

Attachment

*This accessory is currently

not available through

Beha-Amprobe.

Trace Wires Inside Conduit

Trace energized and de-energized wires enclosed in metal

conduit by removing the junction box cover and using the

AT-7000-RE Receiver’s Tip Sensor to identify the specic

wire carrying the transmitted signal generated by the

AT-7000-TE Transmitter. Wires in non-metal conduit can

be traced directly without opening the junction box and

using the AT-7000-RE Receiver’s Smart Sensor

™

Trace energized wires without access

to exposed conductors

The SC-7000-EUR signal clamp accessory can be used

with the AT-7000-TE Transmitter to induce a signal into

energized and de-energized wires when there is no access

to bare conductors. Simply clamp around the desired wire

to induce the signal, then begin tracing.

Use the Tip Sensor to trace wires in

hard to reach areas

When used with the AT-7000-TE Transmitter, the Tip Sensor

pinpoints the location of energized and de-energized wires

in tight, hard to reach spaces. It easily and accurately traces

the targeted energized and de-energized wires in junction

boxes, corners, walls, oors and ceilings to a depth of up to

6.1 meters (20 feet).

Non-contact voltage (NCV) detection

The NCV feature extends functionality of the AT-7000-RE

Receiver by detecting energized wires from 90 to 600 V

and 40 to 400 Hz without the use of the AT-7000-TE

Transmitter. Its adjustable sensitivity ts a range of

applications, from detecting presence of voltage (higher

sensitivity) to precisely pinpointing a hot wire in a bundle

(lower sensitivity).

Trace energized or de-energized wires by removing the junction box cover.

Use the Tip Sensor to trace wires in hard to reach areas.

Induce signal with the signal clamp when there is no bare conductor.

Non-contact voltage (NCV) detection.

Trace wires in hard to reach places with insulation stick.

AT-7000-EUR Features and Functions