User's Manual

Typhoon Wireless Office Desktop

Article No.: 40620

All specifications and information are subject to changes without further notices

3. Then press the ID button on the bottom of the keyboard once.

Note: The whole procedure should be complete within 25 seconds.

Remarks:

1. Please choose only USB or PS/2 system to install your RF keyboard kit, do not mix USB

and PS/2 port under the same system, or it may cause harm to your keyboard kit or PC

system.

 If you choose USB system, only plug in the USB connector into your PC system.

 If you choose PS/2 system, use the keyboard USB to PS/2 adaptor enclosed in the

package to switch the USB port to keyboard PS/2 port.

2. You must follow the procedure above to set the ID. Once the receiver ID button is

pressed you have 25 seconds to complete the entire process, or you will need to begin

again.

3. When the receiver is plugged in, the LED under the receiver ID button will flash. Once the

ID is set, it will remain steadily lit.

4. When changing the batteries of keyboard or mouse, please proceed ID setting (mouse→

receiver or keyboard→receiver) again to ensure the usage of this keyboard kit.

board ID butto