Use and Care Manual

3
Diagram B: Control Panel
Set
Start
Auto
Mode
On/off
Manual
release
Control Button Descriptions
Mode button: Press this button once to set programmed brew start time, twice to set pre-soak time, three times to set brew
temperature, four times to set the current clock and five times to calibrate the temperature. The “ ” and “ ” buttons are used to
increase or decrease the mode settings. See specific instructions below for each mode.
On/Off Button: At any point during operation, press button to cancel any/all procedures.
Auto Button: Use to turn on and off the programmed brew start time.
Manual Release Button: Use to enter the manual release mode, which allows the user to release the water into a pitcher,
Chemex, or other container instead of the Brazen Plus carafe. To brew coffee in manual mode, the filter basket should be
removed and allow the showerhead to dispense water directly into the designated container. Leaving the filter basket in place
during manual mode can overfill the filter basket.
“ ” and “ ” Buttons: Use to increase or decrease the time, the brew temperature and altitude.
Set Button: When setting the programmed brew start time or current time, use the Set button to switching between Hour and
Minute. Also used for switching between °F to °C when setting the brew temperature.
Start Button: Use the Start button to begin the brewing cycles or Calibration.
* Power Saving Sleep Cycle: The Brazen Plus is programmed with a Power Saving Sleep Cycle. After 5 minutes of inactivity
the system will go into this mode and the screen will dim. Press any button to bring the brewer out of this mode.
Initial Set Up and Cleaning
1. Remove all packing materials.
2. Check to ensure all parts and accessories are included and the brewer is not damaged.
3. Wipe out stainless steel reservoir with a damp cloth.
4. Add water (Filtered or bottled water is best) to the calibration fill line. Leave the reservoir lid OFF.
5. Be sure the carafe and filter basket are in place.
6. Plug the Brazen Plus Brewer into the power outlet.
7. Program and Calibrate brewer (see following page)
8. After calibration procedure is complete, fill the reservoir to maximum line (1.2L/ 8 Cup) and place reservoir lid
over reservoir.
9. Press “Start” to run a brewing cycle of water only. This rinses the internal components before the first use. Be
sure carafe and other items are in proper place(s).
10. Wash and rinse the removable components (filter basket, gold filter, carafe, and lid) with mild dishwashing
detergent before the first use.