Specification

TECHNICAL DATA SHEET
This information is provided “as is” and no representations or warranties, either express or implied, of merchantability, tness for a particular purpose or of any other nature
are made with respect to this information or to any product referred to in this information. For SDS or to consult with a Behr Paint Company representative,
call 1-800-854-0133 Ext. 2 (U.S.A. only) or visit behr.com. ©2020 Behr Process Corporation, Santa Ana, CA 92705 U.S.A.
Revised 03/2020
2 of 2
Remove all dust with a tack or wiping cloth. Fill all gaps with
a 100% acrylic, siliconized, paintable caulking, and allow to
completely dry prior to coating.
Glossy Surfaces: For maximum adhesion, sand the surface
thoroughly to provide a rough surface before coating.
WARNING! If you scrape, sand or remove old paint, you
may release lead dust. LEAD IS TOXIC. EXPOSURE TO LEAD
DUST CAN CAUSE SERIOUS ILLNESS, SUCH AS BRAIN DAMAGE,
ESPECIALLY IN CHILDREN. PREGNANT WOMEN SHOULD
ALSO AVOID EXPOSURE. Wear a NIOSH-approved respirator
to control lead exposure. Clean up carefully with a HEPA
vacuum and a wet mop. Before you start, nd out how to
protect yourself and your family by contacting the National
Lead Information Center at 1-800-424-LEAD or log on to
www.epa.gov/lead.
SYSTEM RECOMMENDATIONS:
Although BEHR MARQUEE® Interior Paint is a paint & primer
(self-priming - rst coat is the primer and the second coat
is the nish) over most properly prepared surfaces, it is
recommended for optimum performance to follow the
primer recommendations provided below:
Drywall/Gypsum Wallboard:
• Self-prime using 2 coats of BEHR MARQUEE Interior Paint
or
• 1 coat BEHR® Kitchen, Bath & Trim Interior Stain-Blocking
Primer & Sealer No. 75
2 coats BEHR MARQUEE Interior Paint
Masonry:
• Self-prime using 2 coats of BEHR MARQUEE Interior Paint
or
• 1 coat BEHR® Kitchen, Bath & Trim Interior Stain-Blocking
Primer & Sealer No. 75
2 coats BEHR MARQUEE Interior Paint
Plaster:
• Self-prime using 2 coats of BEHR MARQUEE Interior Paint
or
• 1 coat BEHR® Kitchen, Bath & Trim Interior Stain-Blocking
Primer & Sealer No. 75
2 coats BEHR MARQUEE Interior Paint
Wood:
• Self-prime using 2 coats of BEHR MARQUEE Interior Paint
or
• 1 coat BEHR® Kitchen, Bath & Trim Interior Stain-Blocking
Primer & Sealer No. 75
2 coats BEHR MARQUEE Interior Paint
Stain-Blocking:
• Self-prime using 2 coats of BEHR MARQUEE Interior Paint
or
• 1 coat BEHR Kitchen, Bath & Trim Interior Stain-Blocking
Primer & Sealer No. 75 or BEHR Multi-Surface Interior/
Exterior Stain-Blocking Primer & Sealer No. 436
2 coats BEHR MARQUEE Interior Paint
Ferrous and Non-Ferrous Metals:
• 1 coat BEHR Interior/Exterior Metal Primer No. 435
(recommended for optimal corrosion resistance or when
priming over sound rusty metal surfaces) or BEHR
Multi-Surface Interior/Exterior Stain-Blocking Primer
& Sealer No. 436
2 coats BEHR MARQUEE Interior Paint
Fiberglass, Architectural Plastics‡ (Vinyl, Plexiglass,
ABS, Polypropylene, Polycarbonate):
• Self-prime using 2 coats of BEHR MARQUEE Interior Paint
or
• 1 coat BEHR® Interior/Exterior Bonding Primer No. 432 or
BEHR Multi-Surface Interior/Exterior Stain-Blocking Primer
& Sealer No. 436
2 coats BEHR MARQUEE Interior Paint
‡Due to the diverse nature of plastic substrates, apply a test
patch of the coating or coating system to ensure adhesion is
acceptable. Certain materials used in the manufacturing of
plastics will compromise coating adhesion. Please consult
your Behr sales rep for specic recommendations.
PERFORMANCE DATA:
Scrubbability
ASTM D2486 Scrub > 2000 (no shim)
Flexibility
ASTM D522, method B - Pass
CLEANUP/DISPOSAL:
Clean all tools and equipment with warm, soapy water.
Do not dispose of this product down a drain. If spilled,
contain material and remove with an inert absorbent.
Dispose of contaminated absorbent, container and unused
product in accordance with all current federal, state
and local regulations. For recycling or disposal of empty
containers, unused product and soiled rags, contact your
household refuse collection service.
CAUTIONS/LIMITATIONS:
• Protect from freezing.
• Do not use on oors.
• For best results, apply when air, material and surface
temperatures are between 50°F and 90°F. Temperatures
above 90°F can cause the paint to dry too fast, whereas
temperatures below 50°F can inhibit proper lm formation.
• Avoid heavy trac for 24 hours.
• Allow 4 weeks before washing or cleaning for full cure.
• Shelf life under normal conditions is 2 years unopened.
• Guaranteed one-coat hide excludes ULTRA PURE WHITE®,
colors outside of the MARQUEE One-Coat Hide Color
Collection and all other interior or exterior colors that have
not been included as one-coat hide from other BEHR®
palettes. Multiple coats required when: 1) Painting over
uncoated, porous, or repaired exterior surfaces. 2) Over
woods that contain tannins such as redwood or cedar. 3)
When painting over heavy stains, which may require spot-
priming, multiple coats, and/or longer dry time.
GENERAL INFORMATION:
WARNING! IRRITANT CAUSES EYE AND SKIN
IRRITATION. MAY CAUSE RESPIRATORY TRACT IRRITATION.
CONTAINS ETHYLENE GLYCOL, 2-ETHYLHEXYL BENZOATE,
CRYSTALLINE SILICA AND TITANIUM DIOXIDE. Avoid contact
with skin and eyes and avoid breathing vapors, spray mist
and sanding dust. Sanding, grinding or abrading may
release sanding dust, which may be harmful if inhaled
and has been shown to cause lung damage or cancer with
long term exposure. Do not breathe dust, vapor, or spray
mist. To avoid breathing in dust, vapors, and spray mist,
open windows and doors or use other means to ensure
fresh air entry during application, drying, sanding, and/or
abrading. If properly used, a respirator (NIOSH approved
with particulate pre-lter) may oer additional protection
and should be used if adequate ventilation cannot be
provided; obtain professional advice before using. If you
experience eye watering, headaches, or dizziness during
application or drying, increase fresh air or leave the area.
Avoid contact with eyes and skin. Wash thoroughly after
handling. Close container after each use.
FIRST AID: If you experience diculty in breathing,
leave the area to obtain fresh air. If continued diculty is
experience, get medical assistance immediately. In case of
eye contact, ush immediately with plenty of water for at
least 20 minutes and get medical attention; for skin, wash
thoroughly with soap and water. If swallowed, get medical
attention immediately.
INTERIOR EGGSHELL ENAMEL PAINT
NO. 2450 ULTRA PURE WHITE®