Instructions / Assembly

How to Prepare and Coat a Wood Surface with Advanced DECKOVER

Coating

Step 1

Replace any rotting or unstable boards. You may use a wood ﬁller to ﬁll cracks and

holes larger than 1/4".

Step 4

Pour Advanced DECKOVER coating into a paint tray and work a roller into the tray until

it is fully loaded with coating. For best results, use a 1/2” roller cover.

TIP: For larger areas consider using a 5-gallon bucket and a bucket grid.

Step 2

For nail holes and cracks up to 1/4", completely ﬁll in with Advanced DECKOVER

coating using a nylon/polyester brush prior to coating. Deep holes and cracks may

require additional ﬁlling.

Step 3

Using a 2”–2½” wide brush cut in a 2”–3” wide area around the deck ﬂoor where

the roller cannot reach. Start at a corner and follow the grain of the wood.

TIP: To prevent lap marks, only cut in a small area of 2 to 3 board widths at a time.

Apply Advanced DECKOVER Coating

Step 5

Apply a generous, even coat in the same section as the cut in and roll the coating

approximately 4’ down the boards.

TIP: To avoid lap marks, do not roll onto a new section until the previous section

has been completed.

Step 6

Reload the roller with coating and continue to the next 4' section. As you go, roll back

into the section immediately after the coat is applied. Continue rolling until the ﬁrst

coat is completely applied.

Step 7

Once the ﬁrst coat is completely dry, ﬁll in any remaining cracks if necessary and

roll out the second coat.