TDS
TECHNICAL DATA SHEET
This information is provided "as is" and no representations or warranties, either expressed or implied, of merchantability, tness for a particular purpose or of any other
nature are made with respect to this information or to any product referred to in this information. For MSDS or to consult with a Behr Certied Coatings Professional,
call 1-800-854-0133 Ext. 2 (U.S.A. only). ©2016 Behr Process Corporation Santa Ana, CA 92704 U.S.A.
*For as long as you reside in your home. See label for details.
Revised 12/2016
2 of 2
Metals: Ferrous and Non-Ferrous Metals: All metals
should be clean and free of any oils, rust, mill scale or other
contaminants. All metals require sucient “tooth” or
prole for optimum adhesion and therefore require some
type of sanding, abrasion, or chemical etching. Oil lms:
(especially on new or non-ferrous metals) should be
removed by scrubbing the surface with a detergent and
water solution, and thoroughly rinsed. Rust and Mill
Scale: Remove all rust and mill scale using sandpaper,
steel wool, abrasive blasting, or other abrading methods.
Prole: For best adhesion results, sand all metal
surfaces (including new ones) with sandpaper, steel wool,
or etch using a product such as a muriatic acid etcher.
Clean by scrubbing the surface with a detergent and
water solution, followed by a thorough rinsing with
clean water. All ferrous metals must be primed the
same day it is cleaned to prevent rust.
WARNING! If you scrape, sand or remove old paint, you
may release lead dust. LEAD IS TOXIC. Contact the
National Lead Information Center at 1-800-424-LEAD or
visit www.epa.gov/lead.
RECOMMENDED PRIMER/SYSTEMS:
PREVIOUSLY PAINTED SURFACES:
• Although BEHR PREMIUM PLUS® Paint is a paint &
primer in one over most properly prepared surfaces, it is
recommended for optimum performance to follow the
primer recommendations provided below.
PROPERLY PREPARED NEW SURFACES:
Drywall:
1st Coat: BEHR PREMIUM PLUS Interior Drywall Primer
& Sealer No. 73
2nd Coat: BEHR PREMIUM PLUS Interior Flat Paint
Plaster:
1st Coat: BEHR PREMIUM PLUS All-In-One Primer
& Sealer No. 75
2nd Coat: BEHR PREMIUM PLUS Interior Flat Paint
Wood:
1st Coat: BEHR PREMIUM PLUS All-In-One Primer
& Sealer No. 75
2nd Coat: BEHR PREMIUM PLUS Interior Flat Paint
Tannin/Stainblocking:
• BEHR PREMIUM PLUS All-In-one Primer & Sealer No. 75
Masonry:
• BEHR PREMIUM Basement & Masonry Waterproofer
No. 875 or BEHR PREMIUM Concrete & Masonry
Waterproofer No. 870
• BEHR PREMIUM PLUS All-In-one Primer & Sealer No. 75
Masonry with pH Levels up to 13.0:
• BEHR PREMIUM Basement & Masonry Waterproofer
No. 875 or BEHR PREMIUM Concrete & Masonry
Waterproofer No. 870
Ferrous and Non-Ferrous Metal:
• BEHR PREMIUM PLUS All-In-one Primer & Sealer No. 75
TEST SPECIFICATIONS:
Scrubbability:
ASTM D2486 Scrub > 1000 (no shim)
Flexibility:
ASTM D522, method B - Pass
CLEAN UP:
Clean all tools and equipment with clean water. For disposal
of empty containers and unused product, contact your
household refuse collection service.
CAUTIONS/LIMITATIONS:
• Protect from freezing.
• Do not use on oors.
• For best results, apply at temperatures between
50°F - 90°F. Temperatures above 90°F may aect the
application such as drying too fast. Avoid painting in
direct sun. NOTE: If the surface is hot to the touch it
should be considered too hot to apply this coating.
• Allow two weeks before washing or cleaning for full cure.
• Shelf life under normal conditions is two years unopened.
GENERAL INFORMATION:
Warning! Causes eye and skin irritation. Wear protective
clothing, gloves, eye, and face protection. Do not eat, drink,
or smoke when using this product. Take o contaminated
clothing and wash it before reuse. Wash hands thoroughly
after handling. Dispose of unused contents, container and
other contaminated wastes in accordance with local, state,
federal and provincial regulations.
First aid: If in eyes: Rinse cautiously with water for
several minutes and remove contacts if present and easy
to do. Continue rinsing and get medical attention if eye
irritation persists. If on skin: Wash with plenty of soap
and water. If swallowed: Rinse mouth and get medical
attention if you feel unwell.
INTERIOR FLAT PAINT
NO. 1050 ULTRA PURE WHITE®