Use and Care Manual

CAUTION IRRITANT MAY CAUSE EYE, NOSE AND THROAT
IRRITATION. AVOID CONTACT WITH SKIN AND EYES AND AVOID
BREATHING OF VAPORS AND SPRAY MIST. WEAR EYE PROTECTION
AND PROTECTIVE CLOTHING. USE ONLY WITH ADEQUATE VENTILATION.
To avoid breathing vapors and spray mist, open windows and doors or use other means
to ensure fresh air entry during application and drying. If you experience eye watering,
headaches or dizziness, increase fresh air. If properly used, a respirator (NIOSH approved
for organic vapor with P series particulate pre-filter) may offer additional protection; obtain
professional advice before using. A dust mask does not provide protection against vapors. Avoid
contact with eyes and skin. Wash thoroughly after handling. Close container after each use.
FIRST AID: If you experience difficulty in breathing, leave the area to obtain fresh air. If continued
difficulty is experienced, get medical assistance immediately. In case of eye contact, flush
immediately with plenty of water for at least 20 minutes and get medical attention; for skin,
wash thoroughly with soap and water. If swallowed, get medical attention immediately.
CAUTION: KEEP OUT OF REACH OF CHILDREN – DO NOT TAKE INTERNALLY.
BEHR PREMIUM PLUS
®
Interior Eggshell Enamel
WHERE TO USE
For moderate traffic areas. Ideal for Family Rooms, Living
Rooms, Dining Rooms, Bedrooms, Kids’ Rooms and Hallways.
PREPARATION
All surfaces should be properly prepared and cleaned.
Remove loose paint, wash off dirt and grease with detergent,
rinse and allow to dry. Remove mildew stains with a mildew
stain removing product. Scuff sand glossy surfaces and repair
imperfections. Remove all dust with a damp cloth, allow to dry.
Allow new stucco, plaster and masonry to cure for 30 days
before painting.
PRIME
Use BEHR PREMIUM PLUS
®
Paint as a primer over properly
prepared coated or uncoated surfaces. For stain-blocking,
or over oil-based or glossy surfaces, use a product such as
BEHR
®
KITCHEN, BATH & TRIM STAIN-BLOCKING PRIMER &
SEALER No. 75. For optimal color development, better hide,
and to reduce the number of topcoats with deep colors denoted
with a dagger (†) on the color chip, apply a custom tinted primer
coat of BEHR PREMIUM PLUS Paint. Prime all metal surfaces
before painting.
APPLICATION
Apply when air and surface temperatures are between 50-90° F
(10-32° C). Stir paint occasionally. Intermix containers of same
product to ensure color and sheen uniformity. Use a high quality
3/8-1/2" nap roller cover, nylon/polyester brush or airless
sprayer (.015-.019" spray tip, 60 mesh filter). Do not thin if
using a roller or brush; however, if using a sprayer and thinning
is required, thin with water at a rate of no more than 1/2 pint
per gallon. Certain colors may require more than one coat for
complete hide. Darker colors may require additional dry time
between coats. Cooler temperatures or higher humidity may
prolong drying time. After 4 weeks, cured paint film may be
cleaned with a mild, non-abrasive liquid detergent. Dry paint
film is mildew resistant.
DISPOSAL
For disposal of empty containers, unused paint and soiled rags,
contact your household refuse collection service.
Visit behr.com for painting tips, expert project advice, and the perfect
color coordination with the ColorSmart by BEHR
®
Tool.
WARNING! If you scrape, sand or remove old paint, you may release lead
dust. LEAD IS TOXIC. EXPOSURE TO LEAD DUST CAN CAUSE SERIOUS
ILLNESS, SUCH AS BRAIN DAMAGE, ESPECIALLY IN CHILDREN. PREGNANT
WOMEN SHOULD ALSO AVOID EXPOSURE. Wear a NIOSH-approved
respirator to control lead exposure. Clean up carefully with a HEPA
vacuum and a wet mop. Before you start, find out how to protect yourself
and your family by contacting the National Lead Information Center at
1-800-424-LEAD or log on to www.epa.gov/lead.
©2019 Behr Process Corporation
Santa Ana, CA 92705 U.S.A. • behr.com
V.O.C. < 5 g/L • REV. 08/19
FOR TINT BASES – DO NOT USE WITHOUT THE ADDITION OF TINTING COLORANTS
No. 2050 Ultra Pure White
®
No. 2012 Swiss Coffee
No. 2300 Deep Base
No. 2400 Medium Base
1 Hr Dry Time
2 Hr Recoat Time
250-400 Sq. Ft.
Coverage per Gallon
Protect
from Freezing
Soap & Water
Clean-Up
• Paint & Primer in One
• Excellent Hide
• Resists Dirt & Grime
• Durable, Long-Lasting Finish
• Mildew Resistant Finish
• Low Odor
• 100% Acrylic
• Lifetime Warranty*
• Zero VOC
- This product, like most Zero VOC paints, emits very low amounts of VOCs.
- Most emissions occur during painting and for 48 hours after. Some continue for two weeks or longer.
- While VOC emissions are very low, sensitive groups such as babies and asthma/allergy sufferers
should minimize exposure.
WARNING Cancer and Reproductive Harm – www.P65Warnings.ca.gov
*LIFETIME LIMITED WARRANTY Behr Process Corporation warrants to you, the original
residential consumer purchaser, the performance of this product as described on this label
for so long as you reside in your home. THIS WARRANTY IS NOT VALID WHEN THE PRODUCT IS
NOT PROPERLY APPLIED TO A PROPERLY PREPARED SURFACE OR CARED FOR IN ACCORDANCE
WITH THE LABEL DIRECTIONS. This warranty is not transferable. If this product is found not to
perform as specified on the label during the warranty period, Behr Process Corporation will, at
its option and upon presentation of proof-of-purchase (the original receipt), either furnish an
equivalent amount of new product or refund the original purchase price of this product to you.
This warranty excludes (1) labor and costs of labor for the application or removal of any
product, and (2) any incidental or consequential damages, whether based on breach
of express or implied warranty, negligence, strict liability or any other legal theory.
Some states do not allow the exclusion or limitation of incidental or consequential damages, so
the above limitation or exclusion may not apply to you. This warranty gives you specific legal
rights and you may also have other rights, which vary from state to state. Note to residents of
the State of New Jersey: The provisions of this warranty, including its limitations, are intended
to apply to the fullest extent permitted by the laws of the State of New Jersey. To obtain
warranty service, call 1-800-854-0133. Behr Process Corporation reserves the right to inspect
any and all application of the product prior to processing your claim made under this warranty.
To consult with a Behr Certified Coatings Professional, call 1-800-854-0133 Ext. 2 (U.S.A. only).