TDS
TECHNICAL DATA SHEET
This information is provided "as is" and no representations or warranties, either expressed or implied, of merchantability, tness for a particular purpose or of any other
nature are made with respect to this information or to any product referred to in this information. For SDS or to consult with a Behr Certied Coatings Professional,
call 1-800-854-0133 Ext. 2 (U.S.A. only). ©2019 Behr Process Corporation, Santa Ana, CA 92705 U.S.A.
*For as long as you reside in your home. See label for details.
Revised 10/2019
2 of 2
ESPECIALLY IN CHILDREN. PREGNANT WOMEN SHOULD
ALSO AVOID EXPOSURE. Wear a NIOSH-approved respirator
to control lead exposure. Clean up carefully with a HEPA
vacuum and a wet mop. Before you start, nd out how to
protect yourself and your family by contacting the National
Lead Information Center at 1-800-424-LEAD or log on to
www.epa.gov/lead.
SYSTEM RECOMMENDATIONS:
Although BEHR PREMIUM PLUS® is a paint & primer in one
(self-priming - rst coat is the primer and the second coat
is the nish) over most properly prepared surfaces, it is
recommended for optimum performance to follow the
primer recommendations provided below:
Wood:
• 1 coat BEHR® Multi-Surface Interior/Exterior Stain-
Blocking Primer & Sealer No. 436
2 coats BEHR PREMIUM PLUS Exterior Paint
Masonry: Concrete, Cement, Brick, Stucco, EIFS
• 1 coat BEHR Multi-Surface Interior/Exterior Stain-Blocking
Primer & Sealer No. 436 (recommended for masonry with
pH levels up to 13)
2 coats BEHR PREMIUM PLUS Exterior Paint
Concrete Masonry Units: Concrete Block, Cinder
Block, Split-Face Block
• 1 coat BEHR DRYPLUS® Masonry Waterproofer No. 875
2 coats BEHR PREMIUM PLUS Exterior Paint
Fiber-Cement
• 1 coat BEHR Multi-Surface Interior/Exterior Stain-Blocking
Primer & Sealer No. 436
2 coats BEHR PREMIUM PLUS Exterior Paint
Ferrous and Non-Ferrous Metals:
• 1 coat BEHR Interior/Exterior Metal Primer No. 435
(recommended for optimal corrosion resistance or when
priming over sound rusty metal surfaces) or BEHR Multi-
Surface Interior/Exterior Stain-Blocking Primer & Sealer
No. 436
2 coats BEHR PREMIUM PLUS Exterior Paint
Vinyl, PVC, Fiberglass, Architectural Plastics
• 1 coat BEHR Interior/Exterior Bonding Primer No. 432 or
BEHR Multi-Surface Interior/Exterior Stain-Blocking Primer
& Sealer No. 436
2 coats BEHR PREMIUM PLUS Exterior Paint
NOTE: Certain substrate and exposure conditions, as well
as project requirements, may necessitate the use of other
substrate-specic or solution-driven primers.
PERFORMANCE DATA:
Scrubbability:
ASTM D2486 Scrub > 2500 (no shim)
Biological Growth:
ASTM D3273 (4 weeks) – Pass
Accelerated Weathering:
ASTM D4587, 500 hrs. exposure - Pass
CLEANUP/DISPOSAL:
Clean all tools and equipment with warm, soapy water. Do
not dispose of this product down a drain. If spilled, contain
material and remove with an inert absorbent. Dispose of
contaminated absorbent, container and unused product
in accordance with all current federal, state and local
regulations. For recycling or disposal of empty containers,
unused product and soiled rags, contact your household
refuse collection service.
CAUTIONS/LIMITATIONS:
• Protect from freezing.
• Do not use on oors.
• For best results, apply when air, material and surface
temperatures are between 35°F and 90°F. When the air
temperature is at 35°F, substrates may be colder; prior to
painting, check to be sure the air, surface, and material
temperatures are above 35°F and at least 5°F above the
dew point. Avoid using if rain or snow is expected within
2-3 hours. Do not apply at air or surface temperatures
below 35°F or when air or surface temperatures may
drop below 35°F within 48 hours. Do not apply in direct
sunlight. Temperatures above 90°F can cause the paint to
dry too fast.
• Allow 4 weeks before washing or cleaning for full cure.
• Shelf life under normal conditions is 2 years unopened.
GENERAL INFORMATION:
CAUTION IRRITANT MAY CAUSE EYE, NOSE AND
THROAT IRRITATION. AVOID CONTACT WITH SKIN AND EYES
AND AVOID BREATHING OF VAPORS AND SPRAY MIST. WEAR
EYE PROTECTION AND PROTECTIVE CLOTHING. USE ONLY WITH
ADEQUATE VENTILATION. To avoid breathing vapors and
spray mist, open windows and doors or use other means to
ensure fresh air entry during application and drying. If you
experience eye watering, headaches or dizziness, increase
fresh air. If properly used, a respirator (NIOSH approved for
organic vapor with P series particulate pre-lter) may oer
additional protection; obtain professional advice before
using. A dust mask does not provide protection against
vapors. Avoid contact with eyes and skin. Wash thoroughly
after handling. Close container after each use.
FIRST AID: If you experience diculty in breathing,
leave the area to obtain fresh air. If continued diculty is
experienced, get medical assistance immediately. In case of
eye contact, ush immediately with plenty of water for at
least 20 minutes and get medical attention; for skin, wash
thoroughly with soap and water. If swallowed, get medical
attention immediately.
CAUTION: KEEP OUT OF REACH OF CHILDREN – DO NOT
TAKE INTERNALLY.
EXTERIOR FLAT PAINT
NO. 4050 ULTRA PURE WHITE®