Use and Care Manual

Cabinet & Trim Enamel Interior Semi-Gloss
• Door Won’t Stick After 2 Hours of Dry Time
• Excellent Flow & Leveling
• Dries to a Hard, Durable Finish
• Easy Clean Surface
• Sandable
• Soap & Water Clean-Up
• Mildew-Resistant Finish
NO. 7120 White
NO. 7123 Deep
WHERE TO USE
Recommended for interior wood, drywall, masonry, vinyl and other
properly prepared and primed surfaces. Ideal for kitchen and bathroom
cabinets and doors, windows, trim & molding.
SURFACE PREPARATION
†
(Proper Surface Preparation is Required.)
• All surfaces must be clean, sound, dry and free of any dirt, oil and
grease stains.
• Remove mildew stains with a mildew stain removing product.
• Remove all loose and peeling paint; scuff sand glossy surfaces; caulk
and repair imperfections.
†
Sand all wood surfaces in the direction
of the wood grain to the desired smoothness. Remove all dust from
sanded surfaces with a damp, lint free cloth and allow to dry.
PRIME
• Priming is recommended on all surfaces. On previously painted surface
and on new wood, masonry and vinyl surfaces, or on surface with
heavy stains, prime with a product such as BEHR
®
PRIMER COATINGS
™
Kitchen, Bath & Trim Primer & Sealer No. 75 prior to topcoating with
this product. Follow all label instructions. For best results, sand primer
coat prior to topcoating.
APPLICATION
• Apply when air temperature is between 50-90° F (10-32° C).
• Stir before and during application.
• When working with more than one can of the same product, intermix
to ensure color uniformity.
• Do not thin.
• Brush: Apply a thin coat using a high quality synthetic brush. For best
results, apply paint with a high quality 100% Nylon brush.
• Roller: Use a high quality 1/4” nap roller cover.
• Airless Sprayer: .009” - .015” spray tip, 60 mesh filter.
• OPTIONAL: In between coats, sand lightly with 320-400 grit sand paper.
• Certain colors may require 2 or more coats to achieve complete hide.
• NOTE: If touch-up is necessary, same application method is
recommended.
DRY TIME
• Darker colors may require additional dry time. Longer dry time
required in cooler temperatures and higher humidity.
• Cabinets, doors and windows can be closed as early as 2 hours after
final topcoat.
• After 2 weeks, cured paint film may be cleaned with a mild, non-
abrasive liquid detergent. Dry paint film is mildew resistant.
• Do not use on floors.
DISPOSAL
• Properly dispose of all soiled rags.
• For disposal of empty containers and unused product, contact your
household refuse collection service.
• To reduce waste, consult with your retailer or an online paint
calculator to determine the correct amount of paint to purchase.
LIMITED WARRANTY
• Visit www.behr.com/warranty or call 1-800-854-0133 Ext. 2 for more
information.
† WARNING If you scrape, sand or remove old paint, you may release lead
dust. LEAD IS TOXIC Contact the National Lead Information Center at
1-800-424-LEAD or log on to www.epa.gov/lead .
©2019 Behr Process Corporation
Santa Ana, CA 92705 U.S.A. • behr.com
V.O.C. <50 g/L • REV. 9/19
2 Coats Recommended
for Optimal Durability
Clean-Up:
Soap & Water
Dry Time:
1 Hr. Dry to Touch
2 Hr. Recoat
Spread Rate:
Up to 400 sq ft Coverage
WHITE BASE: READY TO USE OR ADD TINTING COLORANTS.
DEEP BASE: DO NOT USE WITHOUT THE ADDITION OF TINTING COLORANTS.
CAUTION IRRITANT MAY CAUSE EYE, NOSE AND THROAT
IRRITATION. AVOID CONTACT WITH SKIN AND EYES AND AVOID
BREATHING OF VAPORS AND SPRAY MIST. WEAR EYE PROTECTION
AND PROTECTIVE CLOTHING. USE ONLY WITH ADEQUATE VENTILATION.
To avoid breathing vapors and spray mist, open windows and doors or use other means
to ensure fresh air entry during application and drying. If you experience eye watering,
headaches or dizziness, increase fresh air. If properly used, a respirator (NIOSH approved
for organic vapor with P series particulate pre-filter) may offer additional protection; obtain
professional advice before using. A dust mask does not provide protection against vapors.
Avoid contact with eyes and skin. Wash thoroughly after handling. Close container after each
use. FIRST AID: If you experience difficulty in breathing, leave the area to obtain fresh air.
If continued difficulty is experienced, get medical assistance immediately. In case of eye contact,
flush immediately with plenty of water for at least 20 minutes and get medical attention; for
skin, wash thoroughly with soap and water. If swallowed, get medical attention immediately.
CAUTION: KEEP OUT OF REACH OF CHILDREN – DO NOT TAKE INTERNALLY.
WARNING Cancer and Reproductive Harm – www.P65Warnings.ca.gov.