Use and Care Manual
TECHNICAL DATA SHEET
Revised 1/2019
2 of 2
RECOMMENDED PRIMER/SYSTEMS:
Drywall/Wallboard:
Self-priming using 2 coats of BEHR PRO® PR105 Interior Flat
Wall & Ceiling Dead Flat
or
1 coat:
BEHR PRO High Build Interior Primer No. 40,
BEHR PREMIUM PLUS® Interior Drywall Primer &
Sealer No. 73
or
KILZ® PVA Drywall Primer
No. P10
2 coats: PR105 Interior Flat Wall & Ceiling Dead Flat
Wood:
1 coat:
BEHR PREMIUM PLUS® Interior Drywall Primer &
Sealer No. 73
or
KILZ PREMIUM® Water-Base Primer
2 coats: PR105 Interior Flat Wall & Ceiling Dead Flat
Tannin / Stainblocking:
1 coat:
BEHR PREMIUM PLUS® Interior/Exterior Multi-Surface
Primer & Sealer No. 436
or
KILZ COMPLETE® Oil-Base
Primer
2 coats: BEHR PRO PR105 Interior Flat Wall & Ceiling Dead Flat
Masonry with pH Levels up to 13.0:
1 coat:
BEHR PREMIUM PLUS® Interior/Exterior Multi-Surface
Primer & Sealer No. 436
2 coats: BEHR PRO PR105 Interior Flat Wall & Ceiling Dead Flat
CLEAN UP:
Clean all tools and equipment with clean water.
For disposal of empty containers and unused product,
contact your household refuse collection service.
CAUTIONS/LIMITATIONS:
•
IMPORTANT! Do not open can without reading instructions.
• Interior use only.
• Do not use on floors.
• Do not use when air and surface temperatures are below
35°F or above 90°F.
• Allow 2 weeks for full cure before washing or cleaning.
• Shelf life under normal conditions is two years unopened.
• Keep from freezing.
GENERAL INFORMATION:
CAUTION IRRITANT MAY CAUSE EYE, NOSE AND
THROAT IRRITATION. AVOID CONTACT WITH SKIN AND EYES
AND AVOID BREATHING OF VAPORS AND SPRAY MIST. WEAR
EYE PROTECTION AND PROTECTIVE CLOTHING. USE ONLY
WITH ADEQUATE VENTILATION. To avoid breathing vapors
and spray mist, open windows and doors or use other means
to ensure fresh air entry during application and drying. If you
experience eye watering, headaches or dizziness, increase
fresh air. If properly used, a respirator (NIOSH approved for
organic vapor with P series particulate pre-filter) may offer
additional protection; obtain professional advice before
using. A dust mask does not provide protection against
vapors. Avoid contact with eyes and skin. Wash thoroughly
after handling. Close container after each use.
FIRST AID: If you experience difficulty in breathing, leave
the area to obtain fresh air. If continued difficulty is
experienced, get medical assistance immediately. In case of
eye contact, flush immediately with plenty of water for at
least 20 minutes and get medical attention; for skin, wash
thoroughly with soap and water. If swallowed, get medical
attention immediately.
i100 INTERIOR FLAT WALL AND CEILING PAINT
DEAD FLAT
NO. PR105
This information is provided "as is" and no representations or warranties, either expressed or implied, of merchantability, fitness for a particular purpose or of any other
nature are made with respect to this information or to any product referred to in this information. For SDS or to consult with a Behr Certified Coatings Professional, call
1-800-854-0133 Ext. 2 (U.S.A. only). ©2019 Behr Process Corporation Santa Ana, CA 92705 U.S.A.


