TDS
TECHNICAL DATA SHEET
This information is provided "as is" and no representations or warranties, either expressed or implied, of merchantability, tness for a particular purpose or of any other
nature are made with respect to this information or to any product referred to in this information. For SDS or to consult with a Behr Certied Coatings Professional,
call 1-800-854-0133 Ext. 2 (U.S.A. only). ©2015 Behr Process Corporation Santa Ana, CA 92704 U.S.A.
*This product does not protect users against food-borne (or disease-causing) bacteria.
Revised 11/2015
2 of 2
contaminants. All metals require sucient “tooth” or prole
for optimum adhesion and therefore require some type of
sanding, abrasion, or chemical etching. Oil lms:
(especially on new or non-ferrous metals) should be
removed by scrubbing the surface with a detergent
and water solution, and thoroughly rinsed. Rust and Mill
Scale: Remove all rust and mill scale using sandpaper,
steel wool, abrasive blasting, or other abrading methods.
Prole: For best adhesion results, sand all metal surfaces
(including new ones) with sandpaper, steel wool, or
etch using a product such as a muriatic acid etcher.
Clean by scrubbing the surface with a detergent and
water solution, followed by a thorough rinsing with
clean water. All ferrous metals must be primed the same
day it is cleaned to prevent rust.
WARNING! If you scrape, sand or remove old paint,
you may release lead dust. LEAD IS TOXIC. Contact the
National Lead Information Center at 1-800-424-LEAD or
visit www.epa.gov/lead.
RECOMMENDED PRIMER/SYSTEMS:
Drywall/Wallboard:
• BEHR PREMIUM PLUS® Interior Drywall Primer &
Sealer No. 73
• BEHR PREMIUM PLUS Interior All-In-One Primer &
Sealer No. 75
• KILZ 2® Interior/Exterior Water-Based Primer
Wood:
• BEHR PREMIUM PLUS Interior All-In-One Primer &
Sealer No. 75
• BEHR PREMIUM PLUS® Interior/Exterior Multi-Surface
Primer & Sealer No. 436
• KILZ 2 Interior/Exterior Water-Based Primer
Tannin / Stainblocking:
• BEHR PREMIUM PLUS Interior/Exterior Multi-Surface
Primer & Sealer No. 436
• KILZ 2 Interior/Exterior Water-Based Primer
Masonry with pH Levels up to 13.0:
• BEHR PREMIUM PLUS Interior/Exterior Multi-Surface
Primer & Sealer No. 436
Ferrous and Non-Ferrous Metal:
• BEHR PREMIUM PLUS Interior/Exterior Multi-Surface
Primer & Sealer No. 436
TEST SPECIFICATIONS:
Scrubbability:
ASTM D2486 Scrub > 1000 (no shim)
Flexibility:
ASTM D522 Flexibility - Pass
CLEAN UP:
Clean all tools and equipment with clean water.
For disposal of empty containers and unused product,
contact your household refuse collection service.
CAUTIONS/LIMITATIONS:
• I
MPORTANT! Do not open can without reading instructions.
• For tint bases – do not use without the addition of colorant.
• Interior use only.
• Do not use on oors.
• Do not use when air and surface temperatures are below
35°F or above 90°F.
• Allow 2 weeks for full cure before washing or cleaning.
• Shelf life under normal conditions is two years unopened.
• Keep from freezing.
GENERAL INFORMATION:
Warning! Causes eye and skin irritation. Wear protective
clothing, gloves, eye, and face protection. Do not eat, drink,
or smoke when using this product. Take o contaminated
clothing and wash it before reuse. Wash hands thoroughly
after handling. Dispose of unused contents, container and
other contaminated wastes in accordance with local, state,
federal and provincial regulations.
First aid: If in eyes: Rinse cautiously with water for several
minutes and remove contacts if present and easy to do.
Continue rinsing and get medical attention if eye irritation
persists. If on skin: Wash with plenty of soap and water.
If swallowed: Rinse mouth and get medical attention
if you feel unwell.
i300 INTERIOR EGGSHELL PAINT
NO. 330