TDS

TECHNICAL DATA SHEET
This information is provided "as is" and no representations or warranties, either expressed or implied, of merchantability, tness for a particular purpose or of any other
nature are made with respect to this information or to any product referred to in this information. For MSDS or to consult with a Behr Certied Coatings Professional,
call 1-800-854-0133 Ext. 2 (U.S.A. only). ©2017 Behr Process Corporation Santa Ana, CA 92704 U.S.A.
Revised 1/2017
2 of 2
steel wool, or by using a product such as a muriatic acid
etcher. Clean by scrubbing the surface with a detergent
and water solution, followed by a thorough rinsing
with clean water.
Metal: Remove all rust and mill scale using sandpaper, steel
wool, abrasive blasting, or other abrading methods to create
a prole on the metal’s surface. New Surfaces: Clean the
metal by scrubbing the surface with a detergent and water
solution, followed by a thorough rinsing with clean water.
Bare metal must be primed the same day it is cleaned.
WARNING! If you scrape, sand or remove old paint,
you may release lead dust. LEAD IS TOXIC. Contact the
National Lead Information Center at 1-800-424-LEAD
or visit www.epa.gov/lead.
RECOMMENDED PRIMER/SYSTEMS:
PROPERLY PREPARED NEW SURFACES:
Drywall, Plaster, Masonry, Non-Ferrous Metal,
and Wood:
• 2 coats is the minimum required for new
or uncoated surfaces.
For Severe Tannin/Stain-blocking:
• BEHR PREMIUM PLUS® Interior All-In-One Primer
& Sealer No. 75
PREVIOUSLY PAINTED SURFACES:
• Use a full coat, or spot prime repaired, or uncoated
surfaces such as woods with heavy tannins
(Redwood and Cedar) with BEHR PREMIUM PLUS ULTRA®
Paint and Primer in One.
TEST SPECIFICATIONS:
Flexibility
ASTM D522, method B - Pass
Scrubbability
ASTM D2486, > 3000 (no shim)
Sealing Properties
ASTM E97, < 7% Change in Reectance
Burnish
ASTM D6736, < 15% Sheen Change
Washability
ASTM D4828 - Pass
CLEAN UP:
Clean all tools and equipment with clean water. For disposal
of empty containers and unused product, contact your
household refuse collection service.
CAUTIONS/LIMITATIONS:
• Protect from freezing.
• Do not use on oors.
• For best results, apply at temperatures between
50°F - 90°F. Temperatures above 90°F may aect the
application such as drying too fast. Avoid painting in direct
sun. NOTE: If the surface is hot to the touch it should be
considered too hot to apply this coating.
• Avoid heavy trac for 24 hours.
• Allow four weeks before washing or cleaning for full cure.
• Shelf life under normal conditions is two years unopened.
GENERAL INFORMATION:
Warning! Causes eye and skin irritation. Wear protective
clothing, gloves, eye, and face protection. Do not eat, drink,
or smoke when using this product. Take o contaminated
clothing and wash it before reuse. Wash hands thoroughly
after handling. Dispose of unused contents, container and
other contaminated wastes in accordance with local, state,
federal and provincial regulations.
First aid: If in eyes: Rinse cautiously with water for several
minutes and remove contacts if present and easy to do.
Continue rinsing and get medical attention if eye irritation
persists. If swallowed: Rinse mouth and get medical
attention if you feel unwell. If on skin: Wash with plenty
of soap and water.
INTERIOR MATTE PAINT
NO. 1750 ULTRA PURE WHITE®