Use and Care Manual

BEHR ULTRA
®
SCUFF DEFENSE
™
Interior Semi-Gloss Enamel
• Stain-Blocking Paint & Primer
◊
• Advanced Scuff & Mar Resistance
• Exceptional Burnish Resistance,
Easy-Clean Finish
• Outstanding Durability for Busy
High-Traffic Areas
• Antimicrobial-Mildew Resistant
Paint Finish
• Lifetime Warranty*
• Low VOC, 100% Acrylic
No. 3750 Ultra Pure White
®
**
No. 3753 Deep Base
No. 3754 Medium Base
◊
A PRIMER COAT MAY BE NEEDED ON SOME SURFACES. SEE BACK LABEL FOR DETAILS.
1 Hr Dry Time
2 Hr Recoat Time
250-400 Sq. Ft.
Coverage
Soap & Water
Clean-Up
Protect
from Freezing
FOR TINT BASES – DO NOT USE WITHOUT THE ADDITION OF TINTING COLORANTS
BEHR ULTRA
®
Scuff Defense
TM
offers a 100% acrylic stain-blocking paint
& primer formula incorporating the breakthrough innovative Scuff Defense
Technology, while delivering a STAYS LOOKING NEW LONGER
R
Finish for
excellent durability.
WHERE TO USE
Properly prepared coated and uncoated Interior surfaces. Ideal for Family
Rooms, Living Rooms, Dining Rooms, Bedrooms, Hallways
and Ceilings.
PREPARATION & PRIME
All surfaces should be properly prepared and cleaned. Remove loose
paint, wash off dirt and grease with detergent, rinse and allow to dry.
Remove mildew stains with a mildew stain remover. Scuff sand glossy
surfaces and repair imperfections. Remove all dust with a damp cloth,
allow to dry. Allow new stucco, plaster and masonry to cure for 30 days
before painting. Use BEHR ULTRA
®
Paint as a primer for properly prepared
uncoated or painted interior surfaces, including woods that contain
tannins (two primer coats required for redwood and cedar) and heavily
stained areas. Lock in stains with BEHR ULTRA Paint as a spot primer. For
heavy stains, test for stain bleed-through by applying BEHR ULTRA Paint
to a small section. If the stain bleeds through, spot prime another coat to
the stained area and test again before topcoating. If bleeding continues,
a longer dry time is needed before topcoating. For drastic color changes
or when applying deep colors denoted with a dagger (†) on the color chip,
apply a tinted primer coat of BEHR ULTRA Paint if needed.
APPLICATION
Apply when air and surface temperatures are between 50-90°F
(10-32°C). Stir paint occasionally. Intermix containers of same
product to ensure color and sheen uniformity. Use a high quality
3/8-1/2” nap roller cover, nylon/polyester brush or an airless sprayer
(.015 - .019” spray tip, 60 mesh filter). Do not thin if using a roller or brush;
however, if using a sprayer and thinning is required, thin with water at a rate of
no more than 1/2 pint per gallon. Certain colors may require additional coats for
complete hide. Darker colors may require additional dry time between coats.
Cooler temperatures or higher humidity may prolong drying time. After 4 weeks,
cured paint film may be cleaned with a mild, non-abrasive liquid detergent.
Dry paint film is mildew resistant. Do not use on floors.
DISPOSAL
For disposal of empty containers, unused paint and soiled rags, contact your
household refuse collection service.
Visit Behr.com for painting tips, expert project advice and the perfect color
coordination with the ColorSmart by BEHR
®
Tool.
WARNING! If you scrape, sand or remove old paint, you may release lead dust.
LEAD IS TOXIC. Contact the National Lead Information Center at
1-800-424-LEAD or log on to www.epa.gov/lead.
*LIFETIME LIMITED WARRANTY Behr Process Corporation warrants to the original residential
consumer purchaser the performance of this product as described on this label for so long
as you reside in your home. THIS WARRANTY IS NOT VALID WHEN THE PRODUCT IS NOT
PROPERLY APPLIED TO A PROPERLY PREPARED SURFACE OR CARED FOR IN ACCORDANCE
WITH THE LABEL DIRECTIONS. This warranty is not transferable. If this product is found not
to perform as specified upon inspection by our representative during the warranty period,
Behr Process Corporation will, at its option and upon presentation of proof-of-purchase
(the original receipt), either furnish an equivalent amount of new product or refund the original
purchase price of this product to you. This warranty excludes (1) labor and costs of labor
for the application or removal of any product, and (2) any incidental or consequential
damages, whether based on breach of express or implied warranty, negligence, strict
liability or any other legal theory. Some states do not allow the exclusion or limitation of
incidental or consequential damages, so the above limitation or exclusion may not apply to
you. This warranty gives you specific legal rights and you may also have other rights, which
vary from state to state.
To consult with a Behr Paint Company Representative, call 1-800-854-0133 Ext. 2 (U.S.A. only).
WARNING Cancer and Reproductive Harm – www.P65Warnings.ca.gov
©2020 BEHR PROCESS CORPORATION
Santa Ana, CA 92705 U.S.A. • behr.com
V.O.C. (C.O.V.) <50 g/L • REV: 09/20
WARNING! CAUSES EYE AND SKIN IRRITATION. MAY CAUSE RESPIRATORY TRACT
IRRITATION. Avoid contact with skin and eyes and avoid breathing vapors, spray mist and
sanding dust. Sanding, grinding or abrading may release sanding dust, which may be harmful
if inhaled and has been shown to cause lung damage or cancer with long term exposure. Do
not breathe dusts, vapor, or spray mist. To avoid breathing in dust, vapors, and spray mist,
open windows and doors or use other means to ensure fresh air entry during application,
drying, sanding, and/or abrading. If properly used, a respirator (NIOSH approved with
particulate pre-filter) may offer additional protection and should be used if adequate ventilation
cannot be provided; obtain professional advice before using. If you experience eye watering,
headaches, or dizziness during application or drying, increase fresh air or leave the area. Avoid
contact with eyes and skin. Wash thoroughly after handling. Close container after each use.
FIRST AID: If you experience difficulty in breathing, leave the area to obtain fresh air. If
continued difficulty is experience, get medical assistance immediately. In case of eye contact,
flush immediately with plenty of water for at least 20 minutes and get medical attention; for
skin, wash thoroughly with soap and water. If swallowed, get medical attention immediately.
CAUTION: KEEP OUT OF REACH OF CHILDREN - DO NOT TAKE INTERNALLY.
**Contains Ethylene Glycol