Use and Care Manual

ManualsBrandsBEHR ULTRA ManualsPaint5 gal. #N260-2 Almond Latte Flat Exterior Paint and Primer in One

BEHR PREMIUM PLUS ULTRA

EXTERIOR FLAT

* No. 4850 Ultra Pure White

No. 4853 Deep Base

*No. 4854 Medium Base

• Stain-Blocking Paint & Primer In One

• Excellent Durability & Hide

in Fewer Coats

• Extra-Protective Shell Guards Against

Damage from Sunlight & Moisture

• Stain & Dirt Resistant

• Low Temperature Application

• Enhanced Mildew Resistant Finish

• Lifetime Warranty*

• Low VOC, 100% Acrylic

WHERE TO USE

Properly prepared and cleaned coated or uncoated exterior surfaces. Ideal

for Wood,Vinyl, Aluminum, Fiber Cement Siding, Metals, Brick, Masonry,

Stucco, Steel and Fences.

PREPARATION & PRIME

Use on properly prepared and cleaned coated and uncoated exterior

surfaces. Countersink nailheads, ﬁll and sand smooth. Remove rust,

loose or peeling paint. Repair imperfections and sand smooth.

Wash off dirt, grease and chalk with detergent and/or powerwash.

Remove mildew stains with a mildew stain removing product.

Clean and sand new or weathered wood. Scuff sand or degloss

smooth or glossy surfaces. Scuff sand or etch metals. Rinse and

allow to dry. Caulk windows, doors and other openings. Allow new

stucco, plaster and masonry to cure for 30 days before painting.

Use BEHR PREMIUM PLUS ULTRA

Paint as a primer for repaired

or uncoated surfaces, including woods that contain tannins

(two primer coats required for redwood and cedar) and heavily

stained areas. Lock in stains with the ﬁrst primer coat; if necessary,

apply a second primer coat of BEHR PREMIUM PLUS ULTRA Paint.

For drastic color changes or when applying deep colors denoted

with a dagger (†) on the color chip, apply a tinted primer coat of

BEHR PREMIUM PLUS ULTRA Paint if needed.

APPLICATION

Apply product on dry substrates when air and surface temperatures

are between 35°-90°F (2°-32°C) and will remain between 35°-90°F

(2°-32°C) for at least 4 hours after applying. Do not paint when rain or

heavy condensation is expected. Stir paint occasionally. Intermix containers

of same product to ensure color and sheen uniformity. On semi-smooth

surfaces, use a high quality 3/8-1/2" nap roller cover, nylon/polyester

brush or an airless sprayer (.015-.021" spray tip, 60 mesh ﬁlter). On rough

surfaces, use a high quality 3/4-1" nap roller cover. Do not thin if using a

roller or brush; however, if using a sprayer and thinning is required, thin

with water at a rate of no more than 1/2 pint per gallon. Certain colors

may require additional coats for complete hide. On heavy stains and

woods that contain tannins, allow 12-16 hours of dry time between

coats. Cooler temperatures or higher humidity may prolong drying time.

After 4 weeks, cured paint ﬁlm may be cleaned with a mild, non-abrasive

liquid detergent. Dry paint ﬁlm is mildew resistant. When applying to

vinyl, color choice must be the same color or lighter than the existing

color. Do not use on ﬂoors.

DISPOSAL

For disposal of empty containers, unused paint and soiled rags, contact

your household refuse collection service.

Visit Behr.com for painting tips, expert project advice and the perfect

color coordination with the ColorSmart by BEHR

Tool.

WARNING! If you scrape, sand or remove old paint, you may release

lead dust. LEAD IS TOXIC. Contact the National Lead Information Center

at 1-800-424-LEAD or log on to www.epa.gov/lead.

WARNING! IRRITANT! HARMFUL IF SWALLOWED. MAY CAUSE EYE, NOSE AND THROAT

IRRITATION. AVOID CONTACT WITH SKIN AND EYES AND AVOID BREATHING OF VAPORS

AND SPRAY MIST. WEAR EYE PROTECTION AND PROTECTIVE CLOTHING. USE ONLY WITH

ADEQUATE VENTILATION. To avoid breathing vapors and spray mist, open windows and

doors or use other means to ensure fresh air entry during application and drying. If you

experience eye watering, headaches or dizziness, increase fresh air. If properly used, a

respirator (NIOSH approved for organic vapor with P series particulate pre-ﬁlter) may offer

additional protection; obtain professional advice before using. A dust mask does not provide

protection against vapors. Avoid contact with eyes and skin. Wash thoroughly after handling.

Close container after each use. FIRST AID: If you experience difﬁculty in breathing, leave

the area to obtain fresh air. If continued difﬁculty is experienced, get medical assistance

immediately. In case of eye contact, ﬂush immediately with plenty of water for at least

15 minutes and get medical attention; for skin, wash thoroughly with soap and water.

If swallowed, get medical attention immediately.

CAUTION: KEEP OUT OF REACH OF CHILDREN - DO NOT TAKE INTERNALLY.

WARNING! This product contains chemicals known to the state of California to cause cancer

and birth defects or other reproductive harm.

Santa Ana, CA 92704 U.S.A. • behr.com

V.O.C. <50 g/L • REV: 9/16

US Patent #7482054

250-400 Sq.

Ft. Coverage

2 Hr Dry Time

4 Hr Recoat Time

Soap & Water

Clean-Up

Protect

from Freezing

FOR TINT BASES – DO NOT USE WITHOUT THE ADDITION OF TINTING COLORANTS.

*LIFETIME LIMITED WARRANTY Behr Process Corporation warrants to the original residential

consumer purchaser the performance of this product as described on this label for so long

as you reside in your home. THIS WARRANTY IS NOT VALID WHEN THE PRODUCT IS NOT

PROPERLY APPLIED TO A PROPERLY PREPARED SURFACE OR CARED FOR IN ACCORDANCE

WITH THE LABEL DIRECTIONS. This warranty is not transferable. If this product is found not

to perform as speciﬁed upon inspection by our representative during the warranty period,

Behr Process Corporation will, at its option and upon presentation of proof-of-purchase

(the original receipt), either furnish an equivalent amount of new product or refund the original

purchase price of this product to you. This warranty excludes (1) labor and costs of labor

for the application or removal of any product, and (2) any incidental or consequential

damages, whether based on breach of express or implied warranty, negligence, strict

liability or any other legal theory. Some states do not allow the exclusion or limitation of

incidental or consequential damages, so the above limitation or exclusion may not apply to

you. This warranty gives you speciﬁc legal rights and you may also have other rights, which

vary from state to state.

To consult with a Behr Certiﬁed Coatings Professional, call 1-800-854-0133 Ext. 2 (U.S.A. only).