TDS

TECHNICAL DATA SHEET
This information is provided "as is" and no representations or warranties, either expressed or implied, of merchantability, tness for a particular purpose or of any other
nature are made with respect to this information or to any product referred to in this information. For SDS or to consult with a Behr Certied Coatings Professional,
call 1-800-854-0133 Ext. 2 (U.S.A. only). ©2019 Behr Process Corporation, Santa Ana, CA 92705 U.S.A.
Revised 8/2019
2 of 2
WARNING! If you scrape, sand or remove old paint, you
may release lead dust. LEAD IS TOXIC. EXPOSURE TO LEAD
DUST CAN CAUSE SERIOUS ILLNESS, SUCH AS BRAIN DAMAGE,
ESPECIALLY IN CHILDREN. PREGNANT WOMEN SHOULD
ALSO AVOID EXPOSURE. Wear a NIOSH-approved respirator
to control lead exposure. Clean up carefully with a HEPA
vacuum and a wet mop. Before you start, nd out how to
protect yourself and your family by contacting the National
Lead Information Center at 1-800-424-LEAD or log on to
www.epa.gov/lead.
SYSTEM RECOMMENDATIONS:
Although BEHR ULTRA™ is a paint & primer in one (self-
priming - rst coat is the primer and the second coat is
the nish) over most properly prepared surfaces, it is
recommended for optimum performance to follow the
primer recommendations provided below:
Wood:
• Self-prime using 2 coats BEHR ULTRA Exterior Paint
or
• 1 coat BEHR® Multi-Surface Interior/Exterior Stain-Blocking
Primer & Sealer No. 436 (recommended for tannin-rich
woods)
2 coats BEHR ULTRA Exterior Paint
Masonry: Concrete, Cement, Brick, Stucco, EIFS
• Self-prime using 2 coats of BEHR ULTRA Exterior Paint
or
• 1 coat BEHR Multi-Surface Interior/Exterior Stain-Blocking
Primer & Sealer No. 436 (recommended for masonry with
pH levels up to 13)
2 coats BEHR ULTRA Exterior Paint
Concrete Masonry Units: Concrete Block, Cinder
Block, Split-Face Block
• 1 coat BEHR DRYPLUS® Masonry Waterproofer No. 875
2 coats BEHR ULTRA Exterior Paint
Fiber-Cement
• Self-prime using 2 coats of BEHR ULTRA Exterior Paint
or
• 1 coat BEHR Multi-Surface Interior/Exterior Stain-Blocking
Primer & Sealer No. 436
2 coats BEHR ULTRA Exterior Paint
Ferrous and Non-Ferrous Metals:
• 1 coat BEHR Interior/Exterior Metal Primer No. 435
(recommended for optimal corrosion resistance or when
priming over sound rusty metal surfaces) or BEHR Multi-
Surface Interior/Exterior Stain-Blocking Primer & Sealer
No. 436
2 coats BEHR ULTRA Exterior Paint
Vinyl, PVC, Fiberglass, Architectural Plastics
• 1 coat BEHR Interior/Exterior Bonding Primer No. 432 or
BEHR Multi-Surface Interior/Exterior Stain-Blocking Primer
& Sealer No. 436
2 coats BEHR ULTRA Exterior Paint
NOTE: Certain substrate conditions and exposure
requirements may require the use of specialized primers.
CLEANUP/DISPOSAL:
Clean all tools and equipment with warm, soapy water.
Do not dispose of this product down a drain. If spilled,
contain material and remove with an inert absorbent.
Dispose of contaminated absorbent, container and unused
product in accordance with all current federal, state
and local regulations. For recycling or disposal of empty
containers, unused product and soiled rags, contact your
household refuse collection service.
CAUTIONS/LIMITATIONS:
• Protect from freezing.
• Do not use on oors.
• For best results, apply when air, material and surface
temperatures are between 35°F and 90°F. When the air
temperature is at 35°F, substrates may be colder; prior to
painting, check to be sure the air, surface, and material
temperatures are above 35°F and at least 5°F above the
dew point. Avoid using if rain or snow is expected within
2-3 hours. Do not apply at air or surface temperatures
below 35°F or when air or surface temperatures may
drop below 35°F within 48 hours. Do not apply in direct
sunlight. Temperatures above 90°F can cause the paint to
dry too fast.
• Allow 4 weeks before washing or cleaning for full cure.
• Shelf life under normal conditions is 2 years unopened.
GENERAL INFORMATION:
CAUTION IRRITANT MAY CAUSE EYE, NOSE AND THROAT
IRRITATION. AVOID CONTACT WITH SKIN AND EYES AND
AVOID BREATHING OF VAPORS AND SPRAY MIST. WEAR EYE
PROTECTION AND PROTECTIVE CLOTHING. USE ONLY WITH
ADEQUATE VENTILATION. To avoid breathing vapors and
spray mist, open windows and doors or use other means to
ensure fresh air entry during application and drying. If you
experience eye watering, headaches or dizziness, increase
fresh air. If properly used, a respirator (NIOSH approved for
organic vapor with P series particulate pre-lter) may oer
additional protection; obtain professional advice before
using. A dust mask does not provide protection against
vapors. Avoid contact with eyes and skin. Wash thoroughly
after handling. Close container after each use.
FIRST AID: If you experience diculty in breathing, leave the
area to obtain fresh air. If continued diculty is experienced,
get medical assistance immediately. In case of eye contact,
ush immediately with plenty of water for at least 20
minutes and get medical attention; for skin, wash thoroughly
with soap and water. If swallowed, get medical attention
immediately.
CAUTION: KEEP OUT OF REACH OF CHILDREN – DO NOT
TAKE INTERNALLY.
EXTERIOR SEMIGLOSS ENAMEL PAINT
NO. 5850 ULTRA PURE WHITE®