Use and Care Manual

No. 7750 ULTRA PURE WHITE
®
No. 7753 Deep Base
No. 7754 Medium Base
1 Hr Dry Time
2 Hr Recoat Time
250-400 Sq. Ft.
Coverage
Soap & Water
Clean-Up
Protect
from Freezing
• Stain-Blocking Paint & Primer
◊
• Scuff Defense – Extra Durable Finish
• Easy Application, Smooth Even Finish
• Outstanding Coverage,
Hide In Fewer Coats
• Easy-Clean Finish, Stays Looking
New Longer
®
• Antimicrobial-Mildew Resistant
Paint Finish
• Lifetime Limited Warranty*
• Low VOC, 100% Acrylic
• Greenguard Gold Certified
BEHR ULTRA
®
Interior Satin Enamel
FOR TINT BASES – DO NOT USE WITHOUT THE ADDITION OF TINTING COLORANTS.
©2024 BEHR PROCESS LLC
Santa Ana, CA 92705 U.S.A. • behr.com
VOC <50 g/L • REV. 08/24
To consult with a Behr Paint Company Representative, call 1-800-854-0133.
*LIFETIME LIMITED WARRANTY
Behr Process LLC warrants to you, the original residential consumer purchaser, the
performance of this product as described on this label for so long as you reside in your
home. THIS WARRANTY IS NOT VALID WHEN THE PRODUCT IS NOT PROPERLY APPLIED
TO A PROPERLY PREPARED SURFACE OR CARED FOR IN ACCORDANCE WITH THE LABEL
DIRECTIONS. This warranty is not transferable. If this product is found not to perform as
specied on the label during the warranty period, Behr Process LLC will, at its option and
upon presentation of proof-of-purchase (the original receipt), either furnish an equivalent
amount of new product or refund the original purchase price of this product to you. This
warranty excludes (1) labor and costs of labor for the application or removal of any
product, and (2) any incidental or consequential damages, whether based on breach
of express or implied warranty, negligence, strict liability or any other legal theory.
Some states do not allow the exclusion or limitation of incidental or consequential damages,
so the above limitation or exclusion may not apply to you. This warranty gives you specic
legal rights and you may also have other rights, which vary from state to state. To obtain
warranty service, call 1-800-854-0133. Behr Process LLC reserves the right to inspect any
and all application of the product prior to processing your claim made under this warranty.
◊
A PRIMER COAT MAY BE NEEDED ON SOME SURFACES. SEE PREPARATION AND PRIME FOR DETAILS.
BEHR ULTRA
®
BEHR ULTRA
®
Interior Paint is a versatile stain-blocking paint & primer with
scuff defense providing an extra durable finish that is easy to clean and STAYS
LOOKING NEW LONGER
®
. ULTRA is easy to apply with a smooth even finish that
has outstanding coverage and hide in fewer coats. The paint film provides an
antimicrobial-mildew resistant finish.
WHERE TO USE
Use on properly prepared, coated and uncoated, interior surfaces such as:
Drywall/Gypsum Board, Plaster, Concrete, Masonry, Brick, Concrete Masonry
Units, Wood, Engineered Wood, Steel, Galvanized Steel, Aluminum, Other Ferrous
Metals, Other Non-Ferrous Metals, Architectural Plastics.
PREPARATION & PRIME
All surfaces should be properly prepared and cleaned. Remove loose paint, wash
off dirt and grease with detergent, rinse and allow to dry. Remove mildew stains
with a mildew stain removing product. Scuff sand glossy surfaces and repair
imperfections. Remove all dust with a damp cloth, allow to dry. Allow new stucco,
plaster and masonry to cure for 30 days before painting. Use BEHR ULTRA
®
Paint
as a primer for properly prepared uncoated or painted interior surfaces, including
woods that contain tannins (two primer coats required for redwood and cedar)
and heavily stained areas. Lock in stains with BEHR ULTRA Paint as a spot primer.
For heavy stains, test for stain bleed-through by applying BEHR ULTRA Paint to a
small section. If the stain bleeds through, spot prime another coat to the stained
area and test again before topcoating. If bleeding continues, a longer dry time is
needed before topcoating. For drastic color changes or when applying deep colors
denoted with a dagger (†) on the color chip, apply a tinted primer coat of BEHR
ULTRA Paint if needed.
APPLICATION
Apply when air and surface temperatures are between 50-90°F (10-32°C).
Stir paint occasionally. Intermix containers of same product to ensure color and
sheen uniformity. Use a high quality 3/8-1/2” nap roller cover, nylon/polyester
brush or an airless sprayer (.015 - .019” spray tip, 60 mesh filter). Do not thin
if using a roller or brush; however, if using a sprayer and thinning is required,
thin with water at a rate of no more than 1/2 pint per gallon. Certain colors may
require additional coats for complete hide. Darker colors may require additional
dry time between coats. Cooler temperatures or higher humidity may prolong
drying time. After 2 weeks, cured paint film may be cleaned with a mild,
non-abrasive liquid detergent. Dry paint film is mildew resistant. Do not use
on floors.
DISPOSAL
For disposal of empty containers, unused paint and soiled rags, contact your
household refuse collection service.
Visit Behr.com for painting tips, expert project advice and the perfect
color coordination with the ColorSmart by BEHR
®
Tool.
WARNING If you scrape, sand or remove old paint, you may release lead
dust. LEAD IS TOXIC. Contact the National Lead Information Center at
1-800-424-LEAD or log on to www.epa.gov/lead.
WARNING: This product can expose you to chemicals including ethylene oxide, which
is known to the State of California to cause cancer and birth defects or other reproductive
harm. For more information go to www.P65Warnings.ca.gov.
WARNING! IRRITANT. CAUSES EYE AND SKIN IRRITATION.
MAY CAUSE RESPIRATORY TRACT IRRITATION. MAY CONTAIN:
CRYSTALLINE SILICA AND TITANIUM DIOXIDE. Avoid contact with skin
and eyes and avoid breathing vapors, spray mist and sanding dust. Sanding, grinding or abrading
may release sanding dust, which may be harmful if inhaled and has been shown to cause
lung damage or cancer with long term exposure. Do not breathe dusts, vapor, or spray mist.
To avoid breathing in dust, vapors, and spray mist, open windows and doors or use other
means to ensure fresh air entry during application, drying, sanding, and/or abrading.
If properly used, a respirator (NIOSH approved with particulate pre-lter) may offer
additional protection and should be used if adequate ventilation cannot be provided;
obtain professional advice before using. If you experience eye watering, headaches, or
dizziness during application or drying, increase fresh air or leave the area. Avoid contact
with eyes and skin. Wash thoroughly after handling. Close container after each use.
FIRST AID: If you experience difculty in breathing, leave the area to obtain fresh air.
If continued difculty is experienced, get medical assistance immediately. In case of eye contact,
ush immediately with plenty of water for at least 20 minutes and get medical attention; for
skin, wash thoroughly with soap and water. If swallowed, get medical attention immediately.
KEEP OUT OF REACH OF CHILDREN – DO NOT TAKE INTERNALLY.