TDS
TECHNICAL DATA SHEET
This information is provided "as is" and no representations or warranties, either expressed or implied, of merchantability, tness for a particular purpose or of any other
nature are made with respect to this information or to any product referred to in this information. For MSDS or to consult with a Behr Certied Coatings Professional,
call 1-800-854-0133 Ext. 2 (U.S.A. only). ©2017 Behr Process Corporation Santa Ana, CA 92704 U.S.A.
Revised 1/2017
2 of 2
Ferrous and Non-Ferrous Metal: The oil lm on new
non-ferrous metal must be removed before it is painted.
Remove oil lm with a detergent and water solution.
For better paint adhesion, sand the surface with sandpaper,
steel wool, orby using a product such as a muriatic acid
etcher. Clean by scrubbing the surface with a detergent
and water solution, followed by a thorough rinsing with
clean water. Metal: Remove all rust and mill scale using
sandpaper, steel wool, abrasive blasting, or other
abrading methods to create a prole on the metal’s
surface. New Surfaces: Clean the metal by scrubbing
the surface with a detergent and water solution, followed
by a thorough rinsing with clean water. Bare metal must
be primed the same day it is cleaned.
WARNING! If you scrape, sand or remove old paint,
you may release lead dust. LEAD IS TOXIC. Contact the
National Lead Information Center at 1-800-424-LEAD
or visit www.epa.gov/lead.
RECOMMENDED PRIMER/SYSTEMS:
PROPERLY PREPARED NEW SURFACES:
Drywall, Plaster, Masonry, Non-Ferrous Metal,
and Wood:
• 2 coats is the minimum required for new
or uncoated surfaces.
For Severe Tannin/Stain-blocking:
• BEHR PREMIUM PLUS®
Interior All-In-One Primer & Sealer No. 75
PREVIOUSLY PAINTED SURFACES:
• Use a full coat, or spot prime repaired, or uncoated
surfaces such as woods with heavy tannins
(Redwood and Cedar) with BEHR PREMIUM PLUS ULTRA®
Paint and Primer in One.
CLEAN UP:
Clean all tools and equipment with clean water.
For disposal of empty containers and unused product,
contact your household refuse collection service.
CAUTIONS/LIMITATIONS:
• Protect from freezing.
• Do not use on oors.
• For best results, apply at temperatures between
50°F - 90°F. Temperatures above 90°F may aect the
application such as drying too fast. Avoid painting in
direct sun. NOTE: If the surface is hot to the touch it
should be considered too hot to apply this coating.
• Avoid heavy trac for 24 hours.
• Allow four weeks before washing or cleaning for full cure.
• Shelf life under normal conditions is two years unopened.
GENERAL INFORMATION:
Warning! Causes eye and skin irritation. Wear protective
clothing, gloves, eye, and face protection. Do not eat, drink,
or smoke when using this product. Take o contaminated
clothing and wash it before reuse. Wash hands thoroughly
after handling. Dispose of unused contents, container and
other contaminated wastes in accordance with local, state,
federal and provincial regulations.
First aid: If in eyes: Rinse cautiously with water for several
minutes and remove contacts if present and easy to do.
Continue rinsing and get medical attention if eye irritation
persists. If swallowed: Rinse mouth and get medical
attention if you feel unwell. If on skin: Wash with plenty
of soap and water.
INTERIOR SATIN ENAMEL PAINT
NO. 7750 ULTRA PURE WHITE®