Use and Care Manual

ManualsBrandsBEHR ManualsPaint1 gal. White Acrylic Interior Drywall Plus Primer and Sealer

*LIFETIME LIMITED WARRANTY

Behr Process Corporation warrants to you, the original residential

consumer purchaser, the performance of this product as described on this label for so long as

you reside in your home. THIS WARRANTY IS NOT VALID WHEN THE PRODUCT IS NOT PROPERLY

APPLIED TO A PROPERLY PREPARED SURFACE OR CARED FOR IN ACCORDANCE WITH THE LABEL

DIRECTIONS. This warranty is not transferable. If this product is found not to perform as speciﬁed on

the label during the warranty period, Behr Process Corporation will, at its option and upon presentation

of proof-of-purchase (the original receipt), either furnish an equivalent amount of new product or

refund the original purchase price of this product to you. This warranty excludes (1) labor and costs

of labor for the application or removal of any product, and (2) any incidental or consequential

damages, whether based on breach of express or implied warranty, negligence, strict liability

or any other legal theory. Some states do not allow the exclusion or limitation of incidental or

consequential damages, so the above limitation or exclusion may not apply to you. This warranty

gives you speciﬁc legal rights and you may also have other rights, which vary from state to state. Note

to residents of the State of New Jersey: The provisions of this warranty, including its limitations,

are intended to apply to the fullest extent permitted by the laws of the State of New Jersey. To obtain

warranty service, call 1-800-854-0133. Behr Process Corporation reserves the right to inspect any

and all application of the product prior to processing your claim made under this warranty.

BEHR

Interior

Drywall Plus Primer & Sealer

• Seals Coated and Uncoated Porous

Surfaces Such as Bare Wood

• Recommended for Use Under

Lower Sheen Paints

• High-Hide White

• Quick Recoat Time

• 100% Acrylic

• Tintable up to 2 oz.

of Colorant per Gallon

WHERE TO USE

Over properly prepared uncoated and previously painted Interior

surfaces in low-moisture areas. Ideal for Drywall, Plasterboard,

Wallboard, Wood and Brick. Not recommended under SATIN, SEMI-

GLOSS and HI-GLOSS paint.

PREPARATION

All surfaces should be properly prepared and cleaned. Remove loose

paint, wash off dirt and grease with detergent, rinse and allow to dry.

Remove mildew stains with a mildew stain removing product. Scuff

sand glossy surfaces and repair imperfections. Remove all dust with a

damp cloth, allow to dry. New brick should be thoroughly dried out; test

pH prior to applying primer. The pH must be under 9.0 before coating.

Existing brick should be free of any soot, ash, creosote, grease or other

stains which could affect adhesion of the primer. Remove efﬂoresence

with a mixed solution of one part vinegar and one part water, rinse

thoroughly with clean water and allow to dry.

APPLICATION

Apply when air and surface temperatures are between 50-90° F

(10-32° C). Use a high quality 3/8-1/2" nap roller cover, nylon/polyester

brush or an airless sprayer (.015-.019" spray tip, 60 mesh filter). Stir

primer occasionally. Do not thin if using a roller or brush; however, if

using a sprayer and thinning is required, thin with water at a rate of

no more than 1/2 pint per gallon. Bright or deep colors require a tinted

primer. Have this product tinted close to topcoat color with no more

than 2 ounces of colorant per gallon.

DISPOSAL

For disposal of empty containers, unused paint and soiled rags, contact

your household refuse collection service.

Visit behr.com for painting tips, project advice and color coordination

with the ColorSmart by BEHR

Tool, or download the ColorSmart by

BEHR App on your mobile device.

WARNING! If you scrape, sand or remove old paint, you may release lead

dust. LEAD IS TOXIC. Contact the National Lead Information Center at

1-800-424-LEAD or log on to www.epa.gov/lead.

To consult with a Behr Certiﬁed Coatings Professional, call 1-800-854-0133 Ext. 2 (U.S.A. only).

30 Min Dries to Touch

1 Hr Ready to Topcoat

250-400 Sq. Ft.

Coverage per Gallon

No. 73 White

Protect

from Freezing

Soap & Water

Clean-Up

Santa Ana, CA 92705 U.S.A. • behr.com

V.O.C. < 50 g/L • REV. 05/19

CAUTION IRRITANT MAY CAUSE EYE, NOSE AND THROAT IRRITATION.

AVOID CONTACT WITH SKIN AND EYES AND AVOID BREATHING OF

VAPORS AND SPRAY MIST. WEAR EYE PROTECTION AND PROTECTIVE

CLOTHING. USE ONLY WITH ADEQUATE VENTILATION.To avoid breathing

vapors and spray mist, open windows and doors or use other means to ensure fresh air

entry during application and drying. If you experience eye watering, headaches or dizziness,

increase fresh air. If properly used, a respirator (NIOSH approved for organic vapor with P

series particulate pre-ﬁlter) may offer additional protection; obtain professional advice

before using. A dust mask does not provide protection against vapors. Avoid contact

with eyes and skin. Wash thoroughly after handling. Close container after each use.

FIRST AID: If you experience difﬁculty in breathing, leave the area to obtain fresh air. If

continued difﬁculty is experienced, get medical assistance immediately. In case of eye contact,

ﬂush immediately with plenty of water for at least 20 minutes and get medical attention; for

skin, wash thoroughly with soap and water. If swallowed, get medical attention immediately.

CAUTION: KEEP OUT OF REACH OF CHILDREN – DO NOT TAKE INTERNALLY.

WARNING

Cancer and Reproductive Harm

–

www.P65Warnings.ca.gov