Use and Care Manual

BEHR
®
Paint + Primer
Spray Paint
• Interior/Exterior
• Corrosion Resistant
• Excellent Adhesion
• Advanced Hide
GLOSS
Black Black
52 White
N510-6 Orion Gray
N460-3 Lunar Surface
P450-4 Hidden Sea Glass
M510-7 Inked
P250-7 Blazing Bonfire
N170-7 Baronial Brown
P140-7 No More Drama
P150-7 Flirt Alert
P300-7 Unmellow Yellow
P380-7 Luck of the Irish
PPU11-20 Congo
P340-7 Venom
P450-6 Tropics
P490-7 Mayan Treasure
M130-7 Sugar Beet
N260-6 Outdoor Café
YL-W11 Khaki Shade
M180-2 Resort Sunrise
FLAT
52 White
Black Black
N460-3 Lunar Surface
Clear Clear Coat
Protect
from Freezing
11-15 sq. ft.
Coverage
Mineral Spirits
Clean-Up
BEHR
®
Aerosol features an enhanced formulation that combines
paint and primer in a single can, delivering a premium, durable
finish. Designed for both indoor and outdoor use, BEHR Aerosol can
be used on wood, metal, plastic, cast stone and wicker. Weather
and corrosion resistant, it delivers a reliable, long-lasting finish. The
unique, ergonomic shape of the BEHR Aerosol can and its comfort
tip deliver a superior spray experience that fights fatigue so you
can create a smooth finish every time.
PREPARATION
• The surface must be clean, free of dust, grease, wax, peeling
paint, mold, and mildew. If washing is necessary, use a non-
soapy detergent or a TSP substitute. Rinse well and allow to dry.
• Peeling or Checked Paint: Scrape off loose paint and sand to
a smooth surface. Sanding or removal of paint containing lead
is hazardous.
WARNING! If you scrape, sand or remove old paint, you may release
lead dust. LEAD IS TOXIC. Contact the National Lead Information Center
at 1-800-424-LEAD or log on to www.epa.gov/lead.
• *Glossy Surfaces: For maximum adhesion, scuff sand the
surface thoroughly before painting.
APPLICATION
• Eye protection is recommended.
• For best results, use at room temperature. Cover adjacent
areas to protect from overspray.
• Shake can vigorously for one minute after mixing ball begins to
rattle and often during use. Hold can upright, moving from side-
to-side while spraying lightly and evenly about 12” from area
being painted. Two to three thin coats produce best results.
• Topcoat with BEHR Paint + Primer Clear Aerosol for an added
layer of protection.
DRY TIME
• Longer dry time required in cooler temperatures and
higher humidity.
• 15 Min Dry Time
• Before 1 Hr or After 24 Hr Recoat Time
CLEAN-UP & DISPOSAL
• Clear spray valve immediately after use by turning can upside
down and spraying until only clear gas is released. If spray
nozzle becomes clogged, remove and clean.
• Do not stick pins or wire into can opening.
• Clean fresh overspray with mineral spirits or paint thinner.
Remove dried paint with paint remover, but test small area
first to ensure paint remover does not damage substrate.
• Please consider donating any unused product. For recycling
or disposal information contact your local household refuse
collection service.
Visit behr.com for painting tips, project advice and color coordination
with the ColorSmart by BEHR
®
Tool, or download the ColorSmart by
BEHR App on your mobile device.
WARNING! If you scrape, sand or remove old paint, you may release
lead dust. LEAD IS TOXIC. Contact the National Lead Information Center
at 1-800-424-LEAD or log on to www.epa.gov/lead.
VENTILATION REQUIRED: To avoid inhalation and combustion hazards (see below), DO NOT use this
product unless you can achieve cross ventilation by opening windows and doors during application
and drying. May affect the brain or nervous system causing dizziness, headache or nausea. CAUSES
SERIOUS EYE DAMAGE. IRRITATES SKIN, NOSE AND THROAT. Do not breathe vapors or spray mist.
If you experience eye watering, headaches or dizziness, increase fresh air, wear respiratory protection
(NIOSH/MSHA TC 23C or equivalent) or leave the area. VAPORS MAY IGNITE EXPLOSIVELY. Do not
spray near sparks, heat or open flame. Do not smoke. Vapors are heavier than air and can travel at floor
level to distant ignition sources. Extinguish all flames and pilot lights and turn off stoves, heaters, electric
motors, high intensity lights and other sources of ignition during use and until all vapors are gone.
WARNING-CONTENTS UNDER PRESSURE. Do not puncture or incinerate container. Do not expose to
heat or store at elevated temperatures above 120°F. Prolonged exposure to sun may cause bursting.
FIRST AID: If you have difficulty breathing, leave area to obtain fresh air. If difficulty continues, get
medical attention immediately. If swallowed, call physician immediately. In case of eye contact, flush
immediately with plenty of water for at least 15 minutes and get medical attention. For skin contact,
wash thoroughly with soap and water.
CAUTION: KEEP OUT OF REACH OF CHILDREN – DO NOT TAKE INTERNALLY.
©2019 Behr Process Corporation
Santa Ana, CA 92705 U.S.A. • behr.com
REV. 09/19
*LIMITED WARRANTY For one year from the date of purchase, Behr Process Corporation
warrants to the original consumer purchaser, (1) that the product meets Behr’s manufacturing
specifications, and (2) the performance of this product when applied according to the label
instructions and specifications. If this product is found not to perform as specified on the label
within one year from the date of purchase, Behr Process Corporation will, at its option and upon
presentation of proof-of-purchase (the original receipt), either furnish an equivalent amount of
new product or refund the original purchase price of this product to you. This warranty excludes
(1) labor and costs of labor for the application or removal of any product, and (2) any
incidental or consequential damages, whether based on breach of express or implied
warranty, negligence, strict liability or any other legal theory. Some states do not allow the
exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion
may not apply to you. To the extent permitted by applicable law, any implied warranties
including the implied warranties of merchantability and of fitness for a particular purpose,
are limited to the duration of this express warranty. Some states do not allow limitations on
how long an implied warranty lasts, so the above limitation may not apply to you. This warranty
gives you specific legal rights and you may also have other rights, which vary from state to state.
Note to residents of the State of New Jersey: The provisions of this warranty, including its
limitations, are intended to apply to the fullest extent permitted by the laws of the State
of New Jersey. To obtain warranty service, call 1-800-854-0133. Behr Process Corporation
reserves the right to inspect any and all application of the product prior to processing your claim
made under this warranty.
To consult with a Behr Certified Coatings Professional, call 1-800-854-0133 Ext. 2 (U.S.A. only).
WARNING Cancer and Reproductive Harm – www.P65Warnings.ca.gov