SDS

ManualsBrandsBEHR ManualsGeneral Purpose Spray Paint12 oz. #52 White Flat Interior/Exterior Spray Paint and Primer in One Aerosol

SAFETY DATA SHEET

1. Identification

Behr Aerosol Paint + Primer - White FlatProduct identifier

Other means of identification

B002044

Product code

Architectural Coating

Recommended use

None known.

Recommended restrictions

Manufacturer/Importer/Supplier/Distributor information

Behr Process Corp.

Supplier

1801 E. St. Andrew Place

Santa Ana, CA 92705

714-545-7101

Telephone

(800)-424-9300 CHEMTREC®

Emergency telephone

number

2. Hazard(s) identification

Category 1Flammable aerosols

Physical hazards

Compressed gasGases under pressure

Category 2ASerious eye damage/eye irritation

Health hazards

Category 1Sensitization, skin

Category 2Carcinogenicity

Category 2Reproductive toxicity

Category 3 narcotic effectsSpecific target organ toxicity, single exposure

Category 2 (central nervous system)Specific target organ toxicity, repeated

exposure

Not classified.

OSHA defined hazards

Label elements

Signal word

Danger

Hazard statement

Extremely flammable aerosol. Contains gas under pressure; may explode if heated. May cause an

allergic skin reaction. Causes serious eye irritation. May cause drowsiness or dizziness.

Suspected of causing cancer. Suspected of damaging fertility or the unborn child. May cause

damage to organs (central nervous system) through prolonged or repeated exposure.

Precautionary statement

Prevention

Obtain special instructions before use. Do not handle until all safety precautions have been read

and understood. Keep away from heat/sparks/open flames/hot surfaces. - No smoking. Do not

spray on an open flame or other ignition source. Pressurized container: Do not pierce or burn,

even after use. Do not breathe mist/vapors. Wash thoroughly after handling. Use only outdoors or

in a well-ventilated area. Contaminated work clothing must not be allowed out of the workplace.

Wear protective gloves/protective clothing/eye protection/face protection.

Response

If on skin: Wash with plenty of water. Wash contaminated clothing before reuse. If skin irritation or

rash occurs: Get medical advice/attention. If inhaled: Remove person to fresh air and keep

comfortable for breathing. If exposed or concerned: Get medical advice/attention. If in eyes: Rinse

cautiously with water for several minutes. Remove contact lenses, if present and easy to do.

Continue rinsing. If eye irritation persists: Get medical advice/attention.

Storage

Store in a well-ventilated place. Keep container tightly closed. Store locked up. Protect from

sunlight. Do not expose to temperatures exceeding 50°C/122°F.

Disposal

Dispose of contents/container in accordance with local/regional/national/international regulations.

Behr Aerosol Paint + Primer - White Flat SDS US

950519 Version #: 1.0 Revision date: 8-9-19 Issue date: 8-9-19

1 / 11

Summary of content (11 pages)

PAGE 1
SAFETY DATA SHEET 1. Identification Product identifier Behr Aerosol Paint + Primer - White Flat Other means of identification Product code B002044 Recommended use Architectural Coating Recommended restrictions None known. Manufacturer/Importer/Supplier/Distributor information Supplier Telephone Emergency telephone number Behr Process Corp. 1801 E. St. Andrew Place Santa Ana, CA 92705 714-545-7101 (800)-424-9300 CHEMTREC® 2.
PAGE 2
Hazard(s) not otherwise classified (HNOC) None known. Supplemental information None. 3. Composition/information on ingredients Mixtures Chemical name CAS number % Acetone 67-64-1 10 - 20 Propane 74-98-6 10 - 20 n-Butyl acetate 123-86-4 10 - 20 2-Methoxy-1-methylethyl acetate 108-65-6 2.5 - 10 Isobutane 75-28-5 2.5 - 10 Isobutyl acetate 110-19-0 2.5 - 10 Limestone 1317-65-3 2.5 - 10 Titanium dioxide 13463-67-7 2.5 - 10 Xylene 1330-20-7 1 - 2.5 2-Butanone oxime 96-29-7 0.
PAGE 3
General fire hazards Extremely flammable aerosol. Contents under pressure. Pressurized container may explode when exposed to heat or flame. 6. Accidental release measures Personal precautions, protective equipment and emergency procedures Methods and materials for containment and cleaning up Environmental precautions Keep unnecessary personnel away. Keep people away from and upwind of spill/leak. Keep out of low areas.
PAGE 4
US. OSHA Table Z-3 (29 CFR 1910.1000) Components Titanium dioxide (CAS 13463-67-7) Type Value Form TWA 5 mg/m3 Respirable fraction. 15 mg/m3 Total dust. 50 mppcf Total dust. 15 mppcf Respirable fraction. US.
PAGE 5
US. NIOSH: Pocket Guide to Chemical Hazards Components Type Form Value 100 ppm US. Workplace Environmental Exposure Level (WEEL) Guides Components Type 2-Butanone oxime (CAS 96-29-7) Value TWA 36 mg/m3 10 ppm 2-Methoxy-1-methylethyl acetate (CAS 108-65-6) TWA Biological limit values ACGIH Biological Exposure Indices Components Value 50 ppm Determinant Specimen Sampling Time Acetone (CAS 67-64-1) 25 mg/l Acetone Urine * Toluene (CAS 108-88-3) 0.
PAGE 6
pH Not available. Melting point/freezing point Not available. Initial boiling point and boiling range 1148.5 °F (620.3 °C) estimated Flash point -155.9 °F (-104.4 °C) Propellant estimated Evaporation rate Not available. Flammability (solid, gas) Not applicable. Upper/lower flammability or explosive limits 1.7 % estimated Flammability limit - lower (%) Flammability limit - upper (%) 9 % estimated Vapor pressure 60 - 70 psif (68 °F (20 °C)) estimated Vapor density Not available.
PAGE 7
Components Species Test Results Dermal LD50 Rabbit > 1000 mg/kg, 24 Hours Oral LD50 Rat > 900 mg/kg 2-Butanone oxime (CAS 96-29-7) Acute 2-Methoxy-1-methylethyl acetate (CAS 108-65-6) Acute Dermal LD50 Rabbit > 5000 mg/kg Oral LD50 Rat > 8532 mg/kg Dermal LD50 Rabbit > 15700 mg/kg, 24 Hours Inhalation Vapor LC50 Rat 76 mg/l, 4 Hours Oral LD50 Rat 5800 mg/kg Mouse 52 mg/l, 1 Hours Dermal LD50 Rabbit > 5000 mg/kg Oral LD50 Rat 13400 mg/kg Inhalation LC50 Rat 2000 ppm, 4 Hour
PAGE 8
Components Species Test Results Dermal LD50 Rabbit 12200 mg/kg Inhalation Vapor LC50 Rat 28.1 mg/l, 4 Hours Rat 3523 mg/kg Toluene (CAS 108-88-3) Acute Xylene (CAS 1330-20-7) Acute Oral LD50 Skin corrosion/irritation Prolonged skin contact may cause temporary irritation. Serious eye damage/eye irritation Causes serious eye irritation. Respiratory or skin sensitization Not a respiratory sensitizer. Respiratory sensitization Skin sensitization May cause an allergic skin reaction.
PAGE 9
Waste from residues / unused products Contaminated packaging Dispose of in accordance with local regulations. Empty containers or liners may retain some product residues. This material and its container must be disposed of in a safe manner (see: Disposal instructions). Since emptied containers may retain product residue, follow label warnings even after container is emptied. Empty containers should be taken to an approved waste handling site for recycling or disposal. Do not re-use empty containers. 14.
PAGE 10
Xylene (CAS 1330-20-7) Listed. SARA 304 Emergency release notification Not regulated. OSHA Specifically Regulated Substances (29 CFR 1910.1001-1053) Not listed. Toxic Substances Control Act (TSCA) Superfund Amendments and Reauthorization Act of 1986 (SARA) SARA 302 Extremely hazardous substance Not listed.
PAGE 11
Isobutyl acetate (CAS 110-19-0) Limestone (CAS 1317-65-3) n-Butyl acetate (CAS 123-86-4) Propane (CAS 74-98-6) Titanium dioxide (CAS 13463-67-7) Toluene (CAS 108-88-3) Xylene (CAS 1330-20-7) US. Pennsylvania Worker and Community Right-to-Know Law Acetone (CAS 67-64-1) Isobutane (CAS 75-28-5) Isobutyl acetate (CAS 110-19-0) Limestone (CAS 1317-65-3) n-Butyl acetate (CAS 123-86-4) Propane (CAS 74-98-6) Titanium dioxide (CAS 13463-67-7) Toluene (CAS 108-88-3) Xylene (CAS 1330-20-7) US.