SDS

ManualsBrandsBEHR ManualsInterior Wood Stain & Finishes1 qt. Gloss Clear Oil-Based Interior Fast Drying Polyurethane

SAFETY DATA SHEET

1. Identification

BEHR Oil-Based Fast-Drying Polyurethane GlossProduct identifier

Other means of identification

B7104

Product code

Architectural Coating

Recommended use

None known.

Recommended restrictions

Manufacturer/Importer/Supplier/Distributor information

Behr Process Corp.

Supplier

1801 E. St. Andrew Place

Santa Ana, CA 92705

714-545-7101

Telephone

+1 760 476 3962

Emergency telephone

+1 866 519 4752

335213

Access code

2. Hazard(s) identification

Category 3Flammable liquids

Physical hazards

Category 2Serious eye damage/eye irritation

Health hazards

Category 1Sensitization, skin

Category 2Carcinogenicity

Category 2Reproductive toxicity

Category 1 (central nervous system)Specific target organ toxicity, repeated

exposure

Not classified.

OSHA defined hazards

Label elements

Signal word

Danger

Hazard statement

Flammable liquid and vapor. May cause an allergic skin reaction. Causes serious eye irritation.

Suspected of causing cancer. Suspected of damaging fertility or the unborn child. Causes

damage to organs (central nervous system) through prolonged or repeated exposure.

Precautionary statement

Prevention

Obtain special instructions before use. Do not handle until all safety precautions have been read

and understood. Keep away from heat/sparks/open flames/hot surfaces. - No smoking. Keep

container tightly closed. Ground/bond container and receiving equipment. Use explosion-proof

electrical/ventilating/lighting equipment. Use only non-sparking tools. Take precautionary

measures against static discharge. Do not breathe mist/vapors. Wash thoroughly after handling.

Do not eat, drink or smoke when using this product. Contaminated work clothing must not be

allowed out of the workplace. Wear protective gloves/protective clothing/eye protection/face

protection.

Response

If on skin (or hair): Take off immediately all contaminated clothing. Rinse skin with water/shower.

If skin irritation or rash occurs: Get medical advice/attention. Wash contaminated clothing before

re-use. If in eyes: Rinse cautiously with water for several minutes. Remove contact lenses, if

present and easy to do. Continue rinsing. If eye irritation persists: Get medical advice/attention. In

case of fire: Use appropriate media to extinguish.

Storage

Store in a well-ventilated place. Keep cool. Store locked up.

Disposal

Dispose of contents/container in accordance with local/regional/national/international regulations.

BEHR Oil-Based Fast-Drying Polyurethane Gloss SDS US

951205 Version #: 00 Revision date: 10/31/19 Issue date: 10/31/19

1 / 10

Summary of content (10 pages)

PAGE 1
SAFETY DATA SHEET 1. Identification Product identifier BEHR Oil-Based Fast-Drying Polyurethane Gloss Other means of identification Product code B7104 Recommended use Architectural Coating Recommended restrictions None known. Manufacturer/Importer/Supplier/Distributor information Supplier Telephone Emergency telephone Access code Behr Process Corp. 1801 E. St. Andrew Place Santa Ana, CA 92705 714-545-7101 +1 760 476 3962 +1 866 519 4752 335213 2.
PAGE 2
Hazard(s) not otherwise classified (HNOC) Rags, steel wool, or waste contaminated with this product may spontaneously catch fire if improperly discarded. To avoid a spontaneous combustion fire, immediately after use, place rags, steel wool or waste in a sealed, water-filled, metal container. Supplemental information None. 3.
PAGE 3
Specific methods In case of fire and/or explosion do not breathe fumes. Move containers from fire area if you can do so without risk. Cool containers exposed to heat with water spray and remove container, if no risk is involved. Use standard firefighting procedures and consider the hazards of other involved materials. General fire hazards Flammable liquid and vapor. Fire fighting equipment/instructions 6.
PAGE 4
US. ACGIH Threshold Limit Values Components Type Value Ethylbenzene (CAS 100-41-4) TWA 20 ppm Xylene (CAS 1330-20-7) STEL 150 ppm TWA 100 ppm US. NIOSH: Pocket Guide to Chemical Hazards Components Type Value Distillates (petroleum), hydrotreated light (CAS 64742-47-8) TWA 100 mg/m3 Ethylbenzene (CAS 100-41-4) STEL 545 mg/m3 Xylene (CAS 1330-20-7) STEL 655 mg/m3 150 ppm TWA 435 mg/m3 100 ppm US.
PAGE 5
Appropriate engineering controls Explosion-proof general and local exhaust ventilation. Good general ventilation should be used. Ventilation rates should be matched to conditions. If applicable, use process enclosures, local exhaust ventilation, or other engineering controls to maintain airborne levels below recommended exposure limits. If exposure limits have not been established, maintain airborne levels to an acceptable level. Provide eyewash station.
PAGE 6
Density 7.35 - 7.75 lb/gal Explosive properties Not explosive. Oxidizing properties Not oxidizing. 10. Stability and reactivity Reactivity The product is stable and non-reactive under normal conditions of use, storage and transport. Chemical stability Material is stable under normal conditions. Possibility of hazardous reactions No dangerous reaction known under conditions of normal use. Conditions to avoid Keep away from heat, hot surfaces, sparks, open flames and other ignition sources.
PAGE 7
Skin corrosion/irritation Prolonged skin contact may cause temporary irritation. Serious eye damage/eye irritation Causes serious eye irritation. Respiratory or skin sensitization Not a respiratory sensitizer. Skin sensitization Germ cell mutagenicity May cause an allergic skin reaction. No data available to indicate product or any components present at greater than 0.1% are mutagenic or genotoxic. Suspected of causing cancer. IARC Monographs.
PAGE 8
14. Transport information DOT UN number UN proper shipping name Transport hazard class(es) Class Subsidiary risk Label(s) Packing group Environmental hazards Marine pollutant Special precautions for user Special provisions Packaging exceptions Packaging non bulk Packaging bulk UN1263 Paint 3 3 III No Read safety instructions, SDS and emergency procedures before handling. B1, B52, IB3, T2, TP1, TP29 150 173 242 15.
PAGE 9
Other federal regulations Clean Air Act (CAA) Section 112 Hazardous Air Pollutants (HAPs) List 2-Ethylhexanoic acid, cobalt salt (CAS 136-52-7) Ethylbenzene (CAS 100-41-4) Xylene (CAS 1330-20-7) Clean Air Act (CAA) Section 112(r) Accidental Release Prevention (40 CFR 68.130) Not regulated. Contains component(s) regulated under the Safe Drinking Water Act. Safe Drinking Water Act (SDWA) US state regulations US.
PAGE 10
BEHR Oil-Based Fast-Drying Polyurethane Gloss 951205 Version #: 00 Revision date: 10/31/19 SDS US Issue date: 10/31/19 10 / 10