Use and Care Manual

©2021 Behr Process Corporation
Santa Ana, CA 92704 U.S.A. • behr.com • REV. 02/21
BEHR
TOTAL FLEX
TM
ELASTOMERIC SEALANT
Ideal for: Baseboards, Window Frames, Door Frames,
Trim, Molding, Siding, Stairs, Skirtings, Window Sills,
Corner Joints, Pipes, Vents, Sinks, Countertops,
Tubs and Shower Surrounds
PRODUCT INFORMATION
Use for sealing connection joints and filling cracks or screw/nail holes in walls and ceilings.
Paint-ready (brush/roll) in 1 hour; spray paint immediately
Compatible with water-based and oil-based paints.
Consistent flow/no air pops.
Won’t shine through or discolor paint.
Resists paint cracking.
Weather resistant.
Excellent flexibility and adhesion.
Watertight seal.
Easy gunning and smooth tooling.
Each 10.1 fl oz cartridge will cover 55 linear feet with a 3/16” bead.
Reduced dirt pick-up.
Low VOC & low odor.
Easy water clean-up.
For exterior/interior use.
DIRECTION FOR USE
All surfaces must be clean and free of dust, chalk, oil, grease, wax, polish, mold and mildew stains, rust, loose material and all other
foreign substances. Using proper safety precautions, cut the tip at a 45° angle to desired bead size. Apply with conventional hand or
air-powered caulking equipment in a continuous operation with adequate pressure to fill the joint to the proper width and depth (do
not overfill the joint). Gun sealant into void to provide a solid fill. Use backer rod for gaps larger than 1/2” x 1/2”. Smooth using a dry
tool or a slightly wet spatula if necessary. Allow 1 hour for sealant skin to form before painting with a brush/roller, or spray paint
immediately. When finished be sure to remove and clean up all excess wet sealant with a damp sponge before it skins over. Excess
dried sealant must be cut or scraped away. Reseal cartridge for storage and reuse. away. Reseal cartridge for storage and reuse.
WARNING
Cancer and Reproductive Harm – www.P65Warnings.ca.gov
CAUTION IRRITANT MAY IRRITATE EYES, SKIN, AND RESPIRATORY
TRACT. CONTAINS LIMESTONE, CRYSTALLINE SILICA AND TITANIUM
DIOXIDE. Do not breathe fumes. Do not get in eyes, on skin or on clothing.
Do not swallow. Handle with care. Use only in well-ventilated area or
wear a respirator. Wear protective clothing including safety glasses and
gloves. Wash thoroughly after handling.
FIRST AID: If in eyes or on skin, rinse with
water for at least 15 minutes. If on clothes, remove clothing. If inhaled, move person to fresh
air. If swallowed, call a Poison Control Center or doctor immediately. Do not induce vomiting.
KEEP OUT OF REACH OF CHILDREN – DO NOT TAKE INTERNALLY.

Summary of content (1 pages)