User Manual

ManualsBrandsBehringer ManualsEurorack and Modular Synthesizers1016 Dual Noise / Random Voltage Generator - DOUBLE MODULE NOISE AND RANDOM VOLTAGE GENERATOR

Quick Start Guide

DUAL NOISE / RANDOM

VOLTAGE GENERATOR

MODULE 1016

Legendary 2500 Series Dual Noise

Source Module for Eurorack

Controls

(1) LEDs – Indicate whether the associated knob is active.

(2) NOISE knob – Attenuates the output of the noise

generator.

(3) SLOW RANDOM knob – Attenuates the output of the

slow random voltage generator.

(4) WHITE/PINK/OFF switch – Selects between white or

pink noise, or disengage the output.

(5) OFF/ON switch – Engages or disengages the slow

random voltage output.

(6) NOISE A/B – Send the noise A and B signals to other

modules via 3.5 mm TS cable.

(7) RANDOM A/B – Send the random voltage signals to other

modules via 3.5 mm TS cable.

Power Connection

The unit comes with the required power cable for connecting

to a standard Eurorack power supply system. Follow these

steps to connect power to the module. It is easier to make

these connections before the module has been mounted into

a rack case.

1. Turn the power supply or rack case power o and

disconnect the power cable.

2. Insert the 16-pin connector on the power cable into the

socket on the power supply or rack case. The connector has

a tab that will align with the gap in the socket, so it cannot

be inserted incorrectly. If the power supply does not have

a keyed socket, be sure to orient pin 1 (-12 V) with the red

stripe on the cable.

3. Insert the 10-pin connector into the socket on the back of

the module. The connector has a tab that will align with the

socket for correct orientation.

4. After both ends of the power cable have been securely

attached, you may mount the module in a case and turn on

the power supply.

(1)

(2)

(3)

(4)

(5)

(6) (7)

V 1.0

Summary of content (2 pages)

PAGE 1
Quick Start Guide DUAL NOISE / RANDOM VOLTAGE GENERATOR MODULE 1016 Power Connection Legendary 2500 Series Dual Noise Source Module for Eurorack Controls The unit comes with the required power cable for connecting to a standard Eurorack power supply system. Follow these steps to connect power to the module. It is easier to make these connections before the module has been mounted into a rack case. (1) (2) (3) (4) (5) (6) (7) (1) LEDs – Indicate whether the associated knob is active.
PAGE 2
Installation LEGAL DISCLAIMER The necessary screws are included with the module for mounting in a Eurorack case. Connect the power cable before mounting. Depending on the rack case, there may be a series of fixed holes spaced 2 HP apart along the length of the case, or a track that allows individual threaded plates to slide along the length of the case.