User Manual

3. If you notice a loss of bass frequencies, gently push the earphone deeper
into the ear canal to produce a better seal. If this adjustment does not
improve the bass response, you can also switch to a dierent sleeve.
WARNING: Avoid pushing the earphone in beyond the ear canal.
4. To remove the earphones, rmly hold each earphone’s outer case between
your nger and thumb and twist gently.
Choosing, installing and changing sleeves
MO240 earphones come with a selection of soft sleeves in three sizes,
from small to large.
WARNING: Always make sure to protect your ears by muting or lowering your
monitoring systems volume down all the way before inserting the earphones.
1. Choose an earphone sleeve with the best t and the best seal to isolate your
earphone mix from outside sounds.
2. Slide the sleeve onto each earphone’s sound nozzle. Apply light pressure,
and if necessary rotate the sleeve as you go until secure.
3. Make sure the sleeve completely covers the nozzle and the ared barb.
4. Try inserting the earphone into your ear canal to test the t..
5. If the t is too loose or tight, twist and pull to remove the sleeve from the
nozzle and replace with a sleeve in the next appropriate size.
NOTE: If the barb or nozzle is exposed beneath the sleeve, the sleeve is not
installed properly. Sleeves that do not t securely over the nozzle and barb
should be replaced.
Cleaning
1. If you notice problems with sound quality not related to the t inside
the ear canal, remove the sleeve and check the earphone nozzle for
obstructions.
Other Important Information
Register online. Please register your new Music Tribe equipment right after you
purchase it by visiting behringer.com. Registering your purchase using our simple
online form helps us to process your repair claims more quickly and eciently.
Also, read the terms and conditions of our warranty, if applicable.
Malfunction. Should your Music Tribe Authorized Reseller not be located in your
vicinity, you may contact the Music Tribe Authorized Fulller for your country
listed under “Support” at behringer.com. Should your country not be listed,
please check if your problem can be dealt with by our “Online Support” which may
also be found under “Support” at behringer.com. Alternatively, please submit an
online warranty claim at behringer.com BEFORE returning the product.
2. If the nozzle is blocked, use the included cleaning tool to clear the block.
3. Replace the sleeve onto the nozzle, and re-insert the earphones into your
ear to test the sound.
4. Maintenance tips
• Keep the earphones and sleeves clean and dry.
• To clean, remove the sleeves from the earphone nozzle, gently rinse
in warm water and allow to air dry. Sleeves should be completely
dry before
• Inspect sleeves for damage and replace as necessary.
• Avoid exposing the sleeves to extreme temperatures.
• Replace sleeves that do not t properly.
Nozzle
Nozzle Cleaning Tool
Specications
Driver Dynamic and balanced armature
Crossover frequency 500 Hz
Impedance 32 Ω
Frequency response 20 Hz to 20 kHz
Sound pressure level (SPL) 93 dB @1kHz (102 dB peak)
Rated power 3 mW
Peak power 5 mW
Cable Shielded, detachable
Connector MMCX connector
Cable length 1.5 m (59")
Plug 3.5 mm, stereo
Adapter 6.3 mm, gold plated