002FX/1202FX XENYX Users Manual Version 1.
XENYX 1002FX/1202FX IMPORTANT SAFETY INSTRUCTIONS DETAILED SAFETY INSTRUCTIONS: 1) Read these instructions. 2) Keep these instructions. 3) Heed all warnings. 4) Follow all instructions. CAUTION: To reduce the risk of electric shock, do not remove the top cover (or the rear section). No user serviceable parts inside; refer servicing to qualified personnel. 5) Do not use this apparatus near water. 6) Clean only with dry cloth. 7) Do not block any ventilation openings.
XENYX 1002FX/1202FX FOREWORD Dear Customer, Im sure youre one of those people who have devoted themselves body and soul to your chosen area and no doubt this has made you an expert in your field. Well, for over 30 years, my passion has been music and electronics. This not only led me to establish BEHRINGER, but also enabled me to share my enthusiasm with our employees.
XENYX 1002FX/1202FX output voltage is very low and therefore susceptible to interference. Therefore, mic signal voltage is amplified directly at the mixer input to a higher signal level that is less prone to interference. This higher, interference-safe signal level has to be achieved through amplification using an amplifier of the highest quality in order to amplify the signal and add as little noise to it as possible.
XENYX 1002FX/1202FX 1.3 Before you get started 1.3.1 Shipment Your mixing console was carefully packed in the factory to guarantee safe transport. Nevertheless, we recommend that you carefully examine the packaging and its contents for any signs of physical damage that may have occurred during transit. + + + + + If the unit is damaged, please do NOT return it to us, but notify your dealer and the shipping company immediately, otherwise claims for damage or replacement may not be granted. 2.
XENYX 1002FX/1202FX TRIM Use the TRIM control to adjust the input gain. This control should always be turned fully counterclockwise whenever you connect or disconnect a signal source to one of the inputs. The scale has 2 different value ranges: the first value range (+10 to +60 dB) refers to the MIC input and shows the amplification for the signals fed in there. CLIP The CLIP-LEDs of the mono channels illuminate when the input signal is driven too high, which could cause distortion.
XENYX 1002FX/1202FX 2.
XENYX 1002FX/1202FX LEVEL SETTING: To correctly set the gains of the channels, first set the LEVEL controls of the input channels to their center positions. Then use the TRIM controls to increase the input amplification until signal peaks show 0 dB on the level meter. 2.5 Digital effects processor When recording to digital recorders, the recorders peak meter should not go into overload.
XENYX 1002FX/1202FX 3. APPLICATIONS 3.1 Recording studio Fig. 3.
XENYX 1002FX/1202FX 10
XENYX 1002FX/1202FX 11
XENYX 1002FX/1202FX Headphones output Type Max. output level 5. SPECIFICATIONS Mono inputs Microphone inputs Type XLR, electronically balanced, discrete input circuit Mic E.I.N. (20 Hz - 20 kHz) @ 0 W source resistance @ 50 W source resistance @ 150 W source resistance -132.7 dB / 137 dB A-weighted -130 dB / 133.9 dB A-weighted -127.1 dB / 130.9 dB A-weighted Frequency response <10 Hz - 200 kHz (-1 dB) Gain range Max.
XENYX 1002FX/1202FX 6. WARRANTY § 1 OTHER WARRANTY RIGHTS AND NATIONAL LAW 1. This warranty does not exclude or limit the buyers statutory rights provided by national law, in particular, any such rights against the seller that arise from a legally effective purchase contract. 2. The warranty regulations mentioned herein are applicable unless they constitute an infringement of national warranty law.
