User Manual CABLE TESTER CT100 Professional 6-in-1 Cable Tester
CABLE TESTER CT100 User Manual Table of Contents Important Safety Instructions.................................................................. 3 Legal Disclaimer......................................................................................... 5 Limited warranty....................................................................................... 5 1. Introduction........................................................................................... 6 2. Cable Tester Mode..................
CABLE TESTER CT100 User Manual Important Safety Instructions Terminals marked with this symbol carry electrical current of sufficient magnitude to constitute risk of electric shock. Use only high-quality professional speaker cables with ¼" TS or twist-locking plugs pre-installed. All other installation or modification should be performed only by qualified personnel.
CABLE TESTER CT100 User Manual 8. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. 9. Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the other. A grounding-type plug has two blades and a third grounding prong. The wide blade or the third prong are provided for your safety.
CABLE TESTER CT100 User Manual of natural resources. For more information about where you can take your waste equipment for recycling, please contact your local city office, or your household waste collection service. Legal Disclaimer MUSIC Group accepts no liability for any loss which may be suffered by any person who relies either wholly or in part upon any description, photograph, or statement contained herein.
CABLE TESTER CT100 User Manual 1. Introduction Congratulations! With the CT100, you have purchased an indispensable tool that enables you to easily check the most common cables used by musicians and sound engineers. Faulty cables are a common cause of failure in live and studio situations. This microprocessor-controlled device was designed to ensure fast, reliable problem location. Various test modes and the included belt clip add to its flexibility. 2.
CABLE TESTER CT100 User Manual To test a cable for short circuits, connect one end of the cable to the appropriate OUT jack of the CT100. The display works as in CABLE TESTER MODE (see chapter 2). However, it now indicates connections between out pins. If no LEDs light, the cable is free of short circuits. 3.1 Continuity check in Installed Cable Tester Mode For a continuity check, connect a shorting jack (a jack in which pins are short-circuited to one another) to the other end of the cable.
CABLE TESTER CT100 User Manual 5. Phantom Power Detect In TEST TONE MODE, pins 2 and 3 are monitored for external DC voltage (commonly supplied for condenser microphones). The PHANTOM LEDs will light if DC voltage above approx. 9 V is detected. 6. Wiring Balanced ¼" TRS connector strain relief clamp sleeve ring tip sleeve ground/shield ring cold (-ve) tip hot (+ve) For connection of balanced and unbalanced plugs, ring and sleeve have to be bridged at the stereo plug.
CABLE TESTER CT100 User Manual 1 2 1 3 2 3 output input 1 = ground/shield 2 = hot (+ve) 3 = cold (-ve) For unbalanced use, pin 1 and pin 3 have to be bridged XLR connectors (pin numbers visible on connectors) Pin 2 (tip) Pin 1 (sleeve) RCA connector
CABLE TESTER CT100 User Manual FEDERAL COMMUNICATIONS COMMISSION COMPLIANCE INFORMATION CABLE TESTER CT100 Responsible Party Name: MUSIC Group Services NV Inc. Address: 5270 Procyon Street Las Vegas, NV 89118 USA Phone Number: +1 702 800 8290 CABLE TESTER CT100 complies with the FCC rules as mentioned in the following paragraph: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
We Hear You