Quick Start Guide

V 1.0
Quick Start Guide
SYSTEM 100
297 DUAL PORTAMENTO/
CV UTILITIES
Legendary Analog Portamento
Controller and CV Utilities for Eurorack
Controls
(1) MIXER SIG IN – Connect incoming signals via 3.5 mm
TS cables. Inputs 3 and 4 feed +10/-10 V respectively to
the mixer inputs if no jack is inserted, which can be used
to oset the overall mixer output control voltage.
(2) PORTA SIG OUT – Send the portamento signal to another
module via 3.5 mm TS cable.
(3) PORTA SIG IN – Connect a signal to the portamento
section via 3.5 mm TS cable.
(4) SIG LEVEL – Adjust the level of the signals connected to
the mixer inputs.
(5) INV OUT – Send the mix of inputs 1-4 as an
inverted signal.
(6) NON INV OUT – Send the mix of inputs 1-4 as a
non-inverted signal.
(7) TIME – Adjust the portamento time.
(8) CV IN – Connect a voltage to control the portamento time
from another module.
(9) +10/-10 V LEVEL – Adjust the level of the +10 V and
-10 V outputs.
(10) +10/-10 V OUT – Send the +10 V and -10 V signals via
3.5 mm TS cable.
Power Connection
The module comes with the required power cable for connecting
to a standard Eurorack power supply system. Follow these
steps to connect power to the module. It is easier to make
these connections before the module has been mounted into
a rack case.
1. Turn the power supply or rack case power o and
disconnect the power cable.
2. Insert the 16-pin connector on the power cable into the
socket on the power supply or rack case. The connector has
a tab that will align with the gap in the socket, so it cannot
be inserted incorrectly. If the power supply does not have
a keyed socket, be sure to orient pin 1 (-12 V) with the red
stripe on the cable.
3. Insert the 10-pin connector into the socket on the back of
the module. The connector has a tab that will align with the
socket for correct orientation.
4. After both ends of the power cable have been securely
attached, you may mount the module in a case and turn on
the power supply.
(1)
(4)
(5)
(6)
(3)(2)
(7)
(8)
(10)
(9)