Quick Start Guide

ManualsBrandsBehringer ManualsEurorack SynthesizersLegendary Analog Fixed Filter Bank Module for Eurorack

Quick Start Guide

(EN) Controls

(1) INPUT - Route the incoming signal into the lter bank

via the dual parallel INPUT jacks by using cables

with 3.5 mm TS connectors.

(2) LOW PASS - This knob controls the level of the

xed-frequency low pass lter. The low pass lter will

interact with the lower-frequency bandpass lters.

(3) BANDPASS FILTERS - These 12 knobs control

the output level of the xed-frequency, high-Q bandpass

lters. The level controls can reduce the level of frequencies

centered around the marked frequency. All 14 lters,

including the low and high pass lters, are in parallel

and will interact with each other to allow control

of musical timbre and resonance.

(4) HIGH PASS - This knob controls the level of the

xed-frequency high pass lter. The high pass lter

will interact with the higher-frequency bandpass lters.

(5) OUTPUT - Route the ltered signal back out of the module

via the dual OUTPUT jacks by using cables with 3.5 mm

TS connectors.

(1)

(2) (3) (4)

(5)

Power Connection

The 914 FIXED FILTER BANK module comes with the required power

cable for connecting to a standard Eurorack power supply system.

Follow these steps to connect power to the module. It is easier

to make these connections before the module has been mounted

into a rack case.

1. Turn the power supply or rack case power o

and disconnect the power cable.

2. Insert the 16-pin connector on the power cable into

the socket on the power supply or rack case. The connector

has a tab that will align with the gap in the socket, so it

cannot be inserted incorrectly. If the power supply does not

have a keyed socket, be sure to orient pin 1 (-12 V)

with the red stripe on the cable.

3. Insert the 10-pin connector into the socket on the back

of the module. The connector has a tab that will align

with the socket for correct orientation.

4. After both ends of the power cable have been securely

attached, you may mount the module in a case and turn

on the power supply.

Installation

The necessary screws are included with the module for mounting

in a Eurorack case. Connect the power cable before mounting.

Depending on the rack case, there may be a series of xed holes

spaced 2 HP apart along the length of the case, or a track that allows

individual threaded plates to slide along the length of the case.

The free-moving threaded plates allow precise positioning

of the module, but each plate should be positioned in the

approximate relation to the mounting holes in your module

before attaching the screws.

Hold the module against the Eurorack rails so that each

of the mounting holes are aligned with a threaded rail or

threaded plate. Attach the screws part way to start, which will

allow small adjustments to the positioning while you get them

all aligned. After the nal position has been established,

tighten the screws down.

914 FIXED FILTER BANK

Legendary Analog Fixed Filter Bank

Module for Eurorack

V 1.0

Summary of content (9 pages)

PAGE 1
Quick Start Guide 914 FIXED FILTER BANK Power Connection Legendary Analog Fixed Filter Bank Module for Eurorack (EN) Controls (2) (3) (4) The 914 FIXED FILTER BANK module comes with the required power cable for connecting to a standard Eurorack power supply system. Follow these steps to connect power to the module. It is easier to make these connections before the module has been mounted into a rack case.
PAGE 2
914 FIXED FILTER BANK Quick Start Guide Conexión Eléctrica (ES) Controles (2) (1) (3) APORTE - Dirija la señal de entrada al banco de filtros a través de las tomas INPUT paralelas duales mediante cables con conectores TS de 3,5 mm. (2) PASO BAJO - Esta perilla controla el nivel del filtro de paso bajo de frecuencia fija. El filtro de paso bajo interactuará con los filtros de paso de banda de baja frecuencia.
PAGE 3
4 914 FIXED FILTER BANK Quick Start Guide Netzanschluss (DE) Bedienelemente (2) (3) Conexão de Força (PT) Controles (4) (2) (3) (4) Das 914 FIXED FILTER BANK-Modul wird mit dem erforderlichen Stromkabel für den Anschluss an ein Standard-EurorackStromversorgungssystem geliefert. Befolgen Sie diese Schritte, um das Modul mit Strom zu versorgen. Es ist einfacher, diese Verbindungen herzustellen, bevor das Modul in ein Rackgehäuse eingebaut wurde.
PAGE 4
6 914 FIXED FILTER BANK Quick Start Guide Connessione di Alimentazione (IT) Controlli (2) (3) Stroomaansluiting (NL) Bediening (4) (2) (3) (4) Il modulo 914 FIXED FILTER BANK viene fornito con il cavo di alimentazione necessario per il collegamento a un sistema di alimentazione Eurorack standard. Seguire questi passaggi per collegare l’alimentazione al modulo. È più facile effettuare questi collegamenti prima che il modulo sia stato montato in un case rack. (1) 1.
PAGE 5
8 914 FIXED FILTER BANK Quick Start Guide Strömanslutning (SE) Kontroller (2) (1) (1) (2) (3) (3) (2) LÅGPASS- Denna ratt kontrollerar nivån på lågfrekvensfiltret med fast frekvens. Lågpassfiltret kommer att interagera med bandpassfiltret med lägre frekvens. BANDPASSFILTER - Dessa 12 knoppar styr utgångsnivån för det fasta frekvensbandet med hög Q-band filter. Nivåkontrollerna kan minska frekvensen centrerad kring den markerade frekvensen.
PAGE 6
10 914 FIXED FILTER BANK Quick Start Guide Specifications Signal Connections Input 2 x 3.5 mm parallel jacks, AC coupled Impedance 30 kΩ , unbalanced Maximum input level +20 dBu @ 1 kHz Output 2 x 3.5 mm parallel jacks, AC coupled Impedance < 600 Ω, unbalanced Maximum output level +10 dBu Controls Low pass filter 1 x rotary knob Peak frequency 100 Hz Slope 24 dB/oct.
PAGE 7
12 914 FIXED FILTER BANK LEGAL RENUNCIANTE O Music Tribe não se responsabiliza por perda alguma que possa ser sofrida por qualquer pessoa que dependa, seja de maneira completa ou parcial, de qualquer descrição, fotografia, ou declaração aqui contidas. Dados técnicos, aparências e outras informações estão sujeitas a modificações sem aviso prévio. Todas as marcas são propriedade de seus respectivos donos.
PAGE 8
14 914 FIXED FILTER BANK Hereby, Music Tribe declares that this product is in compliance with Directive 2014/30/EU, Directive 2011/65/EU and Amendment 2015/863/EU, Directive 2012/19/EU, Regulation 519/2012 REACH SVHC and Directive 1907/2006/EC. Full text of EU DoC is available at https://community.musictribe.
PAGE 9
We Hear You