Version 1.
ULTRABASS BA115 IMPORTANT SAFETY INSTRUCTIONS 1) Read these instructions. 2) Keep these instructions. 3) Heed all warnings. 4) Follow all instructions. 5) Do not use this speaker cabinet near water. 6) Clean only with dry cloth. 7) Before putting up the speaker cabinet, you will always have to make sure that the ground surface is absolutely firm. A surface that slightly vibrates is unsafe for the cabinet, therefore: the cabinet should only be put up on firm, even ground surfaces.
ULTRABASS BA115 ULTRABASS BA115 High-Performance 600-Watt Bass Cabinet with an Original 15" BUGERA Aluminum Cone Speaker and 1" Horn Driver s Reinforced chamber, front-ported bass cabinet for 600 Watts of power handling s Original BUGERATM HARD ATTACK Aluminum Cone Speaker s Ultra-fast, direct response and incredible attack s Switchable 1" custom-made horn tweeter for high-end punch s Unique tweeter remote control via footswitch or BEHRINGER MIDI FOOT CONTROLLER FCB1010 s Input and link outputs on
ULTRABASS BA115 FOREWORD TABLE OF CONTENTS Dear Customer, welcome to the team of ULTRABASS users, and thank you very much for expressing your confidence in us by purchasing the ULTRABASS BA115 .
ULTRABASS BA115 1. INTRODUCTION 2. CONTROL ELEMENTS AND CONNECTIONS Thank you for expressing your confidence in our products by purchasing the BEHRINGER ULTRABASS BA115. The BA115 is a premium, unusually powerful bass cabinet that was specially developed for deep and responsive sound reproduction. The special BUGERATM aluminum cone speaker used in the BA115 guarantees an amazingly direct attack and impulsive bass.
ULTRABASS BA115 3. APPLICATIONS With a variety of connectors and the option to combine your BA115 with other BEHRINGER equipment, there is a large number of possible applications for your ULTRABASS. The following illustrations show a few of those. Fig. 3.1: Mono setup with the ULTRABASS BX3000T This illustration shows a simple setup with the BEHRINGER ULTRABASS BX3000T bass amplifier. This setup is particularly well suited for practice rooms and smaller venues.
ULTRABASS BA115 Fig. 3.3: Bi-amping: high and low frequencies are separately resproduced by the bass cabinets When using the BASS V-AMP or the BASS V-AMP PRO, you also have the option of using bass cabinets in the bi-amping mode. With bi-amping, high and low frequency ranges are split between different bass cabinets, so that the entire sound spectrum is not simultaneously reproduced on all speakers. In fig. 3.
ULTRABASS BA115 4.2 Audio connections 4. INSTALLATION 4.1 Speaker connector When combining several speakers/cabinets, you should bear in mind the resulting overall impedance. Here are some brief explanations about different kinds of connections: Serial connection: The individual impedance values of the connected speakers are added up. If two 4-Ohm speakers are connected to one another, there is an overall impedance value of 8 Ohms.
ULTRABASS BA115 6. WARRANTY § 1 WARRANTY CARD/ONLINE REGISTRATION To be protected by the extended warranty, the buyer must complete and return the enclosed warranty card within 14 days of the date of purchase to BEHRINGER Spezielle Studiotechnik GmbH, in accordance with the conditions stipulated in § 3. Failure to return the card in due time (date as per postmark) will void any extended warranty claims.
