Quick Start Guide

MODEL D Eurorack Installation
The MODEL D synthesizer can be removed from its factory
chassis and installed into a standard Eurorack chassis
(not supplied). The module width is 70HP.
We recommend that this procedure is undertaken only by
experienced service technicians, to prevent personal injury,
or damage to the unit.
The Eurorack case will need its own suitable power supply
unit to power the MODEL D synthesizer.
A 10-pin connector on the rear of the main PCB of the
MODEL D allows the +12 VDC power supply connection
to be made. A 10-pin to 16-pin adapter ribbon cable is
supplied to connect to your power supply.
Before proceeding, make sure that your
power supply is capable of supplying
+12 VDC, 1 Amp.
Make sure that the connections using the
supplied adapter cable will supply the ground
and power to the correct pins of X23.
Procedure
Follow all steps in the order in which they are presented.
1. Disconnect the power cord and all other
connections to the MODEL D.
2. Undo the 8 screws on the top panel as shown.
There is no need to undo any other screws.
3. Disconnect the two cables from the lower side
of the main PCB of the MODEL D, and remove the
assembly from the chassis.
4. Store the chassis assembly and the power supply
adaptor in a dry safe place.
5. Securely connect the 10-pin end P1 of the
supplied adapter cable to connector X23 on the
Main PCB of the MODEL D.
6. Make sure your power supply is turned
o and disconnected from the AC mains.
7. Make sure that your power supply will
supply the following to the pins of
connector X23, as shown in the
diagram above:
Pins Connection
1 and 2 No Connection
3 to 8 Ground
9 and 10 +12 VDC
Disconnect from
Main PCB
400 mm ± 10
12
910
1
15
2
16
Red Stripe
Supplied Eurorack Power Supply Cable, Part # A74-0001-79446
Connect End P1 to Connector X23 on main PCB
Pins 1 and 2
No Connection
X23
X21 No Connection
Pins 3 to 8
Ground
Pins 9 and 10
+12 VDC
P1 P2
8. Securely connect the 16-pin end P2 of the supplied
adapter cable to your power supply, and double
check all connections are correct.
9. Securely install the MODEL D Synthesizer into your
Eurorack, using 8 screws in the front panel.
10. Perform a full test and safety test before using
the MODEL D.
11. The 3.5 mm MAIN OUT connector on the top panel
is used instead of the ¼" rear outputs which are no
longer present.
Setting the MIDI Channel
Once installed in a Eurorack, the MIDI channel number is
automatically set to channel 1 (as the MIDI switches are
no longer present.)
The MIDI channel can be changed using MIDI OX or
a similar MIDI utility on your computer to send MIDI
SysEx commands directly to the MODEL D via the
USB MIDI connection. Here is a brief guide to the
procedure (see the MIDI SysEx pages in this manual for
the actual SysEx codes sent to the MODEL D):
1. Disable the MIDI Channel Switches by sending
the appropriate SysEx command.
2. Change the MIDI Channel by sending
the appropriate SysEx command.
20 21
快速启动向导
MODEL D