Protocol Manual

music-group.com behringer.com
3
MIDI Push:
• can be assigned to sending control changes, program changes or notes
• parameters are currently ‘Channel’ and ‘Value’
• for CC and Note commands ‘Value’ 0…127 = controller number/note number, and the button
momentarily toggles the controller value/note-on velocity
• to 127 (depressed/released]
• for Program Changes ‘Value’ 0…127 = program/preset number, that will be sent upon
pressingthe button
MIDI Toggle:
•
can be assigned to sending control changes or notes
• parameters are currently ‘Channel’ and ‘Value’
• for CC and Note commands ‘Value’ 0…127 = controller number/note number, and the button
toggles the controller value/note-on velocity
• between value/velocity 127 and 0 with every operation
Please Note:
•
The ASSIGN section also re ects/displays reception of the same MIDI commands that are selected
for transmission
• The MIDI commands assigned to the ASSIGN controls can be transferred to and from stage via
AES50 using the S16 stage box MIDI I/O
MIDIRX/TX > REMOTE
Enables a speci c form of bi-directional MIDI communication for remote controlling a
computer DAW application using control elements of the X32 console.REMOTEcan be used in
3modes,MackieControl,HUIand rawMIDI CC (raw)controllers (see Setup/remote)
• MIDI CC (raw) selected and Remote is enabled+active, thegroup section controls will transmit/
receive the following messages:
MIDI TX Midi Ch Controller Comment
Group 1-8 SELECT
1 Note 64-71 on (127) / o (0), push non-latching
Group 1-8 SOLO 1 CC 32-39 on (127) / o (0), toggle latching
Group 1-8 MUTE 1 CC 40-47 on (127) / o (0), toggle latching
Sends On Fader 1 CC 48 on (127) / o (0), toggle latching
Group DCA 1-8 1 Note 72 on (127) / o (0), push non-latching