Quick Start Guide

DAW Control
1. Press the SETUP button and page right to the ”remote” tab.
2. Enable the Remote Selection button by pressing the rst rotary encoder.
3. Choose Mackie Ctrl or HUI protocol and set the interface to Card MIDI to use the XUF Interface to transmit
MIDI over the same USB / Firewire cable as the audio.
4. Setup either a Mackie Control or HUI control surface in your DAW.
5. Press the REMOTE button on the left side of the X32 to control your DAW .
6. The 8 Output Faders now control the DAW, use the layer switches to toggle the mute buttons between the
following functions: Mute, Transport, Banking and Channel Selection. “Select” and “Solo” buttons will also work.
7. Buttons and Encoders in the ASSIGN section can be assigned to MIDI commands on their setup page.