User Manual DIGITAL MONITOR SPEAKERS MS /MS 24-Bit/192 kHz Digital 40/20-Watt Stereo Near Field Monitors
DIGITAL MONITOR SPEAKERS MS40/MS20 User Manual User Manual Table of Contents Thank you........................................................................ 2 Important Safety Instructions....................................... 3 Legal Disclaimer.............................................................. 3 Limited Warranty............................................................ 3 1. Introduction................................................................ 4 1.1 Before getting started........
DIGITAL MONITOR SPEAKERS MS40/MS20 User Manual Important Safety Instructions Terminals marked with this symbol carry electrical current of sufficient magnitude to constitute risk of electric shock. Use only high-quality professional speaker cables with ¼" TS or twist-locking plugs pre-installed. All other installation or modification should be performed only by qualified personnel.
DIGITAL MONITOR SPEAKERS MS40/MS20 User Manual User Manual 1. Introduction Two digital inputs plus two stereo analog inputs enable you to connect a broad range of sound sources and mix two of them within the loudspeakers. Additionally, we have equipped the MS20/MS40 with a headphone connector. The speakers are magnetically shielded, so you can use them near computer monitors. ◊ This User’s Manual is intended to familiarize you with the unit’s control elements, so that you can master all the functions.
DIGITAL MONITOR SPEAKERS MS40/MS20 User Manual (7) Turn LINE 2 control to adjust the volume level of LINE 2 input (13) . ◊ Attention: High volume levels may damage your hearing and/or your headphones. Please turn the VOLUME controls all the way to the left before powering up the unit. Be sure to always select an appropriate volume level. (8) (10) (9) (11) (16) Fig. 2.3: Rear panel (left monitor) (16) FROM RIGHT SPEAKER connector. Insert the speaker cable from the TO LEFT SPEAKER connector. 3.
DIGITAL MONITOR SPEAKERS MS40/MS20 User Manual User Manual Begin by connecting the left speaker to the right speaker by wiring the attached speaker cable from connector (14) to connector (16) on the left speaker. Connect the analog outputs of your mixer, keyboard or computer sound card to LINE 1 input (12) . Connect a second piece of equipment to LINE 2 inputs (13) . If you own equipment with digital connectors—such as CD or MD players— simply connect them to the digital inputs (8) and (9) .
DIGITAL MONITOR SPEAKERS MS40/MS20 User Manual FEDERAL COMMUNICATIONS COMMISSION COMPLIANCE INFORMATION DIGITAL MONITOR SPEAKERS MS40/MS20 Responsible Party Name: MUSIC Group Services US Inc. Address: 18912 North Creek Parkway, Suite 200 Bothell, WA 98011, USA Phone/Fax No.
We Hear You
