User`s manual

10
ULTRAMIZER PRO DSP1424P
1.3.2 Back panel
Fig. 1.4: Back panel connectors and control elements
18
Use the OPERATING LEVEL switch to adapt the ULTRAMIZERPRO to different operating levels. You
can select a -10dBV semi-pro level used for home recording and a +4dBu level used in professional
studios. This way the ULTRAMIZERPRO is always optimally adapted to the used nominal operating
level.
19
These are the ULTRAMIZERPROs analog INPUTS. The ULTRAMIZERPRO has both XLR and 1/4"
TRS inputs and outputs. Each XLR and jack set is wired parallel and can be used either balanced or
unbalanced.
20
These are the ULTRAMIZERPROs analog OUTPUTS. Also on balanced XLR and 1/4" TRS connectors.
21
SERIAL NUMBER. Please complete and return the warranty card within 14 days of the date of
purchase. Otherwise, you will lose your right to the extended warranty. Alternatively, you can register
online at our website under www.behringer.com.
22
These are the ULTRAMIZERPROs MIDI connectors (MIDI OUT / THRU / IN). Via these connectors
total remote control is possible.
23
This is the MAINS CONNECTOR / FUSE HOLDER / VOLTAGE SELECTOR. Before you connect the
unit, please make sure that the displayed voltage corresponds to your mains supply. Please note that
the AC voltage selection is defined by the position of the fuse holder. If you intend to change the
operating voltage, remove the fuse holder and turn it by 180 degrees before you reinsert it. Matching the
two markers monitors the selected voltage. Please note that, depending on the mains voltage supplied
to the unit, the correct fuse type and rate must be installed (see chapter 6 SPECIFICATIONS). Please
use the enclosed mains cable to connect the unit to the mains power supply.
+ Please note that not all appliances can be used with different mains voltage ratings. Please
check the description on the back of the unit and the box.
1.3.3 Restoring factory defaults
To protect the DSP1424P against user errors, an important edit command has been implemented via a particu-
lar key combination. In normal operating mode the presets cannot be reset to their factory defaults, so as to
secure your own programs as safely as possible. Please proceed as follows to reinitialize the preset default
settings:
+ Press and keep the keys EFFECT and PRESET before powering up the ULTRAMIZERPRO. Then
switch on the DSP1424P and keep the two keys pressed for about two seconds. The program
numbers are counted up and reset to their original default settings.
2. OPERATION
The ULTRAMIZERPRO is one of the latest generation digital processing devices. Especially designed for
processing the total mix or complex music signals. BEHRINGERs past experience in digital and analog
processing devices come together in this new device. In the DSP1424P, the advantages of digital technology
go hand in hand with the warm and powerful sound of analog devices. The ULTRAMIZERPRO combines
multiple functions for the processing of stereo signals in one device. It is a multi-band compressor, a 3D
surround processor, a denoiser as well as an exciter and a bass processor.
2. OPERATION