User`s manual
20
ULTRAMIZER PRO DSP1424P
3.7 The ULTRAMIZERPRO in a MIDI setup
Owing to the integrated MIDI interface you can fully control the DSP1424P in a MIDI setup. The ULTRAMIZERPRO
can both receive and transmit program changes and controller changes. Wire the unit as follows.
Fig. 3.4: The ULTRAMIZERPRO in a MIDI setup
3.8 Saving data via MIDI
The ULTRAMIZERPROs MIDI implementation also allows for archiving one or several presets on an external
storage medium. Proceed as follows:
Connect the MIDI OUT jack of the ULTRAMIZERPRO to the MIDI IN jack of a MIDI data recorder (e.g. se-
quencer). Press the PRESET and IN/OUT keys simultaneously to enter MIDI mode. Set program change
mode to 0 and controller change mode to 3. Now quit MIDI mode by pressing the PRESET key. Use the jog
wheel to select the preset whose data you wish to save. When the preset is activated, its parameters are
transmitted as controller data and can be recorded on a sequencer or similar device. Repeat this routine until
all presets of your choice have been sent to the external data recorder.
To load archived data back into the ULTRAMIZERPRO, you must enable controller reception in MIDI mode
(see 2.5). Then, start the sequencer to automatically transmit each preset data set back to the
ULTRAMIZERPRO. Press the PRESET key, select a program location to store the data and then again press
the PRESET key. If you want to automate MIDI store functions, you must enable the store mode to switch on
the reception of controller #28. This allows you to directly store any modification of the actual preset on the
preset number that is transmitted with the controller. You can also restore a complete preset that has previ-
ously been recorded with a MIDI sequencer on the same location it had before.
3. APPLICATIONS