User Manual EUROPOWER PMP6000 1600-Watt 20-Channel Powered Mixer with Dual Multi-FX Processor and FBQ Feedback Detection System PMP4000 1600-Watt 16-Channel Powered Mixer with Multi-FX Processor and FBQ Feedback Detection System PMP1000 500-Watt 12-Channel Powered Mixer with Multi-FX Processor and FBQ Feedback Detection System
EUROPOWER PMP6000/PMP4000/PMP1000 User Manual Table of Contents Thank you........................................................................ 2 Important Safety Instructions....................................... 3 Legal Disclaimer.............................................................. 3 Limited warranty............................................................. 3 1. Introduction................................................................ 4 1.1 Before you get started....................
EUROPOWER PMP6000/PMP4000/PMP1000 User Manual Important Safety Instructions Terminals marked with this symbol carry electrical current of sufficient magnitude to constitute risk of electric shock. Use only high-quality professional speaker cables with ¼" TS or twist-locking plugs pre-installed. All other installation or modification should be performed only by qualified personnel.
EUROPOWER PMP6000/PMP4000/PMP1000 User Manual 1. Introduction Further advantages are the integrated Voice Canceller that removes vocal passages from playbacks, the FBQ function, which detects feedback frequencies, and the Speaker Processing function for loudspeaker alignment—all with a resolution of 24 bits and 40 kHz. Plus, our tried and tested XENYX Mic Preamps give you crystal-clear audio free of noise and distortion when using microphones.
EUROPOWER PMP6000/PMP4000/PMP1000 User Manual (57) (58) (61) (62) (65) (55) (18) (35) (19) (22) (20) (60) (64) (1) (2) (21) (27) (26) (30) (3) (4) (6) (8) (31) (9) (36) (43) (11) (13) (14) (32) (33) (34) (39) (37) (56) (44) (42) (40) (52) (29) (16) (17) (47) EUROPOWER PMP1000 FRONT PANEL (46) (54) (48)
EUROPOWER PMP6000/PMP4000/PMP1000 User Manual (56) (55) (57) (58) (59) (62) (18) (23) (63) (64) (19) (22) (65) (20) (26) (1) (2) (60) (61) (27) (43) (44) (21) (3) (4) (24) (31) (34) (32) (30) (33) (5) (6) (25) (8) (9) (35) (54) (10) (36) (38) (53) (37) (40) (42) (52) (11) (13) (15) (16) (14) (45) (41) (17) (46) EUROPOWER PMP4000 FRONT PANEL (47) (48) (49)
EUROPOWER PMP6000/PMP4000/PMP1000 User Manual (56) (55) (57) (58) (59) (62) (18) (23) (63) (19) (64) (22) (20) (65) (26) (1) (2) (60) (61) (27) (28) (29) (21) (3) (4) (34) (31) (24) (5) (6) (32) (25) (33) (7) (8) (35) (9) (36) (11) (12) (15) (16) (53) (37) (10) (13) (54) (14) (38) (39) (52) (42) (43) (40) (44) (50) (41) (51) (45) (17) (46) EUROPOWER PMP6000 FRONT PANEL (47) (48) (49)
EUROPOWER PMP6000/PMP4000/PMP1000 User Manual (66) (67) (69) (70) (68) (72) (71) EUROPOWER PMP6000 REAR PANEL 2. Control Elements A detailed description of all functions of your power mixer can be found in the following chapters. Please also refer to the enclosed sheet with the numbered illustrations to get a good overview of the control layout. 2.1 Mono and stereo channels (1) Use the GAIN control to adjust the input gain.
EUROPOWER PMP6000/PMP4000/PMP1000 User Manual ◊ PMP1000: This does not apply to the mono/stereo combination channels 5/6 and 7/8. (27) The AMP MODE switch determines the mode of operation of the PMP amplifier stage: (20) INSERT I/O. Insert points or simply inserts are used to process a signal with dynamic processors or equalizers. They are pre-fader, pre-EQ and pre-MON/ FX SEND.
(31) EUROPOWER PMP6000/PMP4000/PMP1000 User Manual Press the FBQ IN switch to activate the Feedback Detection system (the FBQ will be active only if you have switched on the equalizer (33) before). Frequencies causing feedback are shown by brightly lit fader LEDs. All other LEDs will be darker. Now, cut the frequency range in question until feedback disappears (the LED gets darker or goes out). This function is available for both the main and monitor mix.
EUROPOWER PMP6000/PMP4000/PMP1000 User Manual 2.4.1 Connectors (55) Use the CD/TAPE INPUT jacks (RCA) to connect an external stereo signal, such as a CD player, tape deck or other line-level sources. (56) The VOICE CANCELLER filters vocal-specific frequencies from the CD/TAPE INPUT signal. This function can be used for karaoke, i.e. you can remove the vocals from a song and then sing along with the music yourself. (57) The CD/TAPE OUTPUT provides the line level stereo signal (e.g.
EUROPOWER PMP6000/PMP4000/PMP1000 User Manual Effect Presets of EUROPOWER PMP6000 No. 00 01 02 03 04 05 06 07 08 09 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 EFFECT Description HALL 00-09 SMALL HALL 1 approx. 1.0s reverb decay SMALL HALL 2 approx. 1.2s reverb decay SMALL HALL 3 approx. 1.5s reverb decay MID HALL 1 approx. 1.8s reverb decay MID HALL 2 approx. 2.0s reverb decay MID HALL 3 approx. 2.
EUROPOWER PMP6000/PMP4000/PMP1000 User Manual 4. Installation 4.1 Mains connection The mains connection is made using the enclosed power cord and a standard IEC receptacle. It meets all of the international safety certification requirements. Blown fuses must be replaced by fuses of the same type and rating. ◊ Please make sure that all units have a proper ground connection. For your own safety, never remove or disable the ground conductor from the unit or of the AC power cord. 4.
EUROPOWER PMP6000/PMP4000/PMP1000 User Manual 5. Wiring Examples 4.3 Loudspeaker connections Your power mixer is equipped with high-quality loudspeaker connectors , which ensure safe and trouble-free operation. The connector was especially developed for high-power loudspeakers. Once it is plugged in, it safely locks into position and cannot be accidentally disengaged. It prevents the occurrence of electrical shock and ensures the correct polarity.
EUROPOWER PMP6000/PMP4000/PMP1000 User Manual Subwoofer F.O.H. mix Monitor mix PMP1000 PMP4000 PMP6000 Rear panel EUROPOWER EP2000 Loudspeaker connection for F.O.H and monitor mix (mono) PMP1000/PMP4000/PMP6000 Rear panel (excerpt) EUROLIVE VP1520 EUROLIVE B1800X Subwoofer 2 x BEHRINGER EUROLIVE VP1520 (passive) 2 x BEHRINGER F1220D (active) Fig. 5.2: Bridged mono operation This illustration shows the power mixer with a sub-woofer connected to OUTPUT B.
EUROPOWER PMP6000/PMP4000/PMP1000 User Manual Keyboard ULTRA-G GI100 V-AMP2 Electric bass Vocal mics Electric guitar Stereo channel 13/14 CD player Mono channel 5 Mono channels 1-4 DAT recorder Mono channel 6 CD/tape in CD/tape out Fig. 5.4: Standard set-up (example) The illustration shows just one channel configuration possible, comprising mono and stereo sources and additionally the tape input/output for recording the mix signal or feeding in a playback signal.
EUROPOWER PMP6000/PMP4000/PMP1000 User Manual BEHRINGER EUROLIVE VP1220 BEHRINGER EUROLIVE VP1220 BEHRINGER EUROLIVE B1800X BEHRINGER EUROLIVE B1800X PMP1000/PMP4000/ PMP6000 Rear panel Output B Output A Vocals/voice BEHRINGER XM1800S B1800-Pro Active Subwoofer BEHRINGER EUROPOWER EP2000 Drums/percussion MAIN 1 OUT BEHRINGER B-2 PRO MONO OUT Stereo inputs Keyboard BEHRINGER V-AMP 3 PHONS/CTRL OUT MON 1/2 OUT Headphone amplifier BEHRINGER POWERPLAY PRO-XL HA4700 Drum Computer CD/TAPE I
EUROPOWER PMP6000/PMP4000/PMP1000 User Manual 6. Specifications PMP6000 Microphone Inputs Type Preamp Outputs XLR, electronically balanced input circuit MAIN Type ¼" TRS connectors, unbalanced Mic E.I.N. (20 Hz - 20 kHz) @ 0 Ohm source resistance -134 dB / 136 dB A-weighted Impedance approx. 150 Ohm, unbalanced @ 50 Ohm source resistance -131.5 dB / 134 dB A-weighted Max.
EUROPOWER PMP6000/PMP4000/PMP1000 User Manual PMP4000 Output Power Microphone Inputs RMS @ 1% THD, Both Channels Driven: 8 Ohm per channel 300 W 4 Ohm per channel 600 W RMS @ 1% THD, Bridged Mode: 8 Ohm 1200 W Peak Power, Both Channels Driven: 8 Ohm per channel 400 W 4 Ohm per channel 800 W Peak Power, Bridged Mode: 8 Ohm 1,600 W Power Supply Mains Voltage Type XLR, electronically balanced input circuit Mic E.I.N.
EUROPOWER PMP6000/PMP4000/PMP1000 User Manual Preamp Outputs Output Power MAIN RMS @ 1% THD, Both Channels Driven: Type ¼" TRS connectors, unbalanced 8 Ohm per channel 300 W Impedance approx. 150 Ohm, unbalanced 4 Ohm per channel 600 W Max. output level +21 dBu 8 Ohm Monitor Type ¼" TRS connectors, unbalanced Impedance approx. 150 Ohm, unbalanced Max. output level +21 dBu Type ¼" TRS connectors, unbalanced Impedance approx. 150 Ohm, unbalanced Max.
EUROPOWER PMP6000/PMP4000/PMP1000 User Manual PMP1000 Microphone Inputs Type Stereo Outputs XLR, electronically balanced input circuit Mic E.I.N. (20 Hz - 20 kHz) @ 0 Ohm source resistance -134 dB / 136 dB A-weighted @ 50 Ohm source resistance -131.5 dB / 134 dB A-weighted @ 150 Ohm source resistance -129 dB / 155 dB A-weighted Frequency response < 10 Hz - 200 kHz (-1 dB) < 10 Hz - > 200 kHz (-3 dB) Type RCA Impedance approx. 1 kOhm Max.
EUROPOWER PMP6000/PMP4000/PMP1000 User Manual Power Supply Mains Voltage USA/Canada 120 V~, 60 Hz China/Korea 220 V~, 50/60 Hz Europe/Australia 230 V~, 50 Hz Japan 100 V~, 50 - 60 Hz Fuse 100 - 120 V~ T 5 A H 250 V Fuse 220 - 240 V~ T 5 A H 250 V Power Consumption Power consumption 500 W Mains connector IEC standard receptacle Dimensions/Weight Dimensions (H x W x D) 4.8 x 15.6 x 16.7" 122 x 390 x 425 mm Weight 18.3 lbs / 8.
EUROPOWER PMP6000/PMP4000/PMP1000 User Manual FEDERAL COMMUNICATIONS COMMISSION COMPLIANCE INFORMATION EUROPOWER PMP6000/PMP4000/PMP1000 Responsible Party Name: MUSIC Group Services US Inc. Address: 18912 North Creek Parkway, Suite 200 Bothell, WA 98011, USA Phone/Fax No.
We Hear You