User's Manual
10 EUROPOWER PMP1680S/PMP980S/PMP960M User Manual
5. Wiring Examples
For stereo operation the POWER AMP switch (28) of the PMP980S/PMP1680S
must be set to its upper position (MAIN L/MAIN R). Outputs A and B deliver
the stereo main signal to the P.A. speakers. Two active speakers, wired in
parallel, are connected to the preamp monitor output. They are used as
on-stage monitor speakers. The eects processors can be switched on and
o with a dual footswitch. This set-up is not possible with the PMP960M
(nostereooperationpossible).
Loudspeaker (F.O.H. mix)
PMP1680S
2 x BEHRINGER EUROLIVE
Stack (B1800X & B1220, both passive)
Loudspeaker connection (monitor mix)
2 x BEHRINGER B215A (active)
PMP1680S Front Panel
(excerpt)
Dual footswitch
Fig. 5.1: EUROPOWER mixer as a stereo amplier (example)
Both the PMP980S/PMP1680S and the PMP960M can be set-up for dual mono
operations. The POWER AMP switch (28) must be set to its lower (PMP960M)
orcenter position (PMP980S/PMP1680S). The two loudspeaker outputs
provide the main and monitor signals independently of each other and to two
loudspeakers each, which are wired in parallel.
Loudspeaker connection for F.O.H and
monitor mix (mono)
PMP960M Rear Panel
(excerpt)
2 x BEHRINGER
EUROLIVE F1520
(passive)
2 x BEHRINGER EUROLIVE B1520
(passive)
Fig. 5.2: EUROPOWER as a dual mono amplier (example)