User Manual BASS V-AMP LX1B/BASS V-AMP PRO LX1B PRO The Ultimate Tone Toolbox for Bass/Acoustic/Electric Guitar and Keyboard Amp Modeling
BASS V-AMP LX1B/BASS V-AMP PRO LX1B PRO User Manual Table of Contents Important Safety Instructions....................................... 3 Legal Disclaimer.............................................................. 3 Limited Warranty............................................................ 3 1. Introduction................................................................ 5 1.1 Before you get started....................................................... 5 2. Control Elements......................
BASS V-AMP LX1B/BASS V-AMP PRO LX1B PRO User Manual Important Safety Instructions Terminals marked with this symbol carry electrical current of sufficient magnitude to constitute risk of electric shock. Use only high-quality professional speaker cables with ¼" TS or twist-locking plugs pre-installed. All other installation or modification should be performed only by qualified personnel.
BASS V-AMP LX1B/BASS V-AMP PRO LX1B PRO User Manual “Support” at behringer.com. If your country is not listed, please check if your problem can be dealt with by our “Online Support” which may also be found under “Support” at behringer.com. Alternatively, please submit an online warranty claim at behringer.com BEFORE returning the product. All inquiries must be accompanied by a description of the problem and the serial number of the product.
BASS V-AMP LX1B/BASS V-AMP PRO LX1B PRO User Manual 1. Introduction Congratulations! By purchasing the BASS V-AMP/BASS V-AMP PRO, you have selected a modern virtual bass amplifier that sets new standards in the world of bass preamps. Our primary goal was to achieve the classic sound of bass amps by using “Physical Modeling” and implementing the newest DSP effects.
BASS V-AMP LX1B/BASS V-AMP PRO LX1B PRO User Manual ◊ When the TAP button (11) is depressed, the BASS control changes its • C: This key activates the CABINETS mode. Use the arrow keys to select a type of loudspeaker or a combination of loudspeakers. You can also completely switch off the speaker simulation (“-”). Additional information is available in chapter 5.2. • D: Activates the X-OVER function. Use the arrows to regulate the cut-off frequency between high-pass and low-pass filter.
BASS V-AMP LX1B/BASS V-AMP PRO LX1B PRO User Manual (12) DISPLAY shows the selected effects bank and gives information about the changes occurring while editing. When the tuner is enabled, the display shows the tuning of the connected instrument. When one of the amp simulations numbered 17 - 32 is selected, the LED located in the lower left corner of the DISPLAY lights up.
BASS V-AMP LX1B/BASS V-AMP PRO LX1B PRO User Manual (24) The balanced stereo signal of your BASS V-AMP PRO can be taken at the DI OUT. This output should be connected to two balanced channel inputs on your mixing console. The signal level is set at +4 dBu in studio modes and at -10 dBu for live modes. (36) By using the AUX IN jack input, you can feed an additional stereo signal into your BASS V-AMP. This way, you can play along to a drum computer or a playback.
BASS V-AMP LX1B/BASS V-AMP PRO LX1B PRO User Manual Operation mode Studio 1 (S1) Studio 2 (S2) Studio 3 (S3) Live 1 (L1) Live 2 (L2) Live 3 (L3) BASS V-AMP OUTPUTS L OUTPUTS R Stereo operation with the selected effects and speaker simulations Amp w/out Amp, FX + Cab Sim Cab Sim + FX Amp, Cab Sim + FX DI Out (unprocessed direct signal) Stereo operation: Live EQ, Amp, Cab Sim and FX Bi-Amping mode w/out Cabinet Simulation HP: Live EQ, Amp, FX For Amp with Live EQ w/out Cab Sim LP: without effects
BASS V-AMP LX1B/BASS V-AMP PRO LX1B PRO User Manual To get into the EDIT mode, press both arrow keys simultaneously. By using the keys B - E, you can activate the DRIVE, CABINETS, X-OVER and DENOISER functions respectively. You can then edit these functions by using the arrow keys, and the respective parameters will be shown in the display. To leave EDIT mode again, briefly press the TUNER key.
BASS V-AMP LX1B/BASS V-AMP PRO LX1B PRO User Manual SILVER PANEL: This simulation reproduces the ’67 Fender Bassman—it’s an amp from the legendary “Silverface” series. Shortly after its introduction it became many a bass player’s absolute darling. Paul McCartney used the Bassman on the later Beatles albums and also used it on his first solo album with the Wings.
BASS V-AMP LX1B/BASS V-AMP PRO LX1B PRO User Manual ◊ You can dynamically steer the GAIN control via MIDI by using a foot controller board, such as the BEHRINGER MIDI FOOT CONTROLLER FCB1010. This way, you get even closer to the original sound. BRITISH CLASSIC: This amp model, created by leaning closely to a ’59 Marshall Plexi 100-Watt amp, is particularly well suited for creating clean sounds. The amp was used by Jimi Hendrix, Eric Clapton and Jeff Beck.
BASS V-AMP LX1B/BASS V-AMP PRO LX1B PRO User Manual Cabinet simulations — 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 BYPASS (NO SPEAKER SIMULATION) AMPEG SVT 8 x 10" '97 TRACE ELLIOT 4 x 10" SWR GOLIATH 4 x 10" AMPEG 4 x 10" GALLIEN KRUEGER B120 68 MARSHALL 4 x 12" AMPEG B15 1 x 15" CLOSED BACK COMBO POLYTONE A101 1 x 15" CLOSED BACK COMBO VOX AC100 2 x 15" MESA/BOOGIE 2 x 15" FENDER BASSMAN 2 x 15" WITH JBLs LESLIE 760 CABINET, 1 x 15" + HF-DRIVER SWR 1 x 18" AMPEG SVT 18E, 1 x 18" S
BASS V-AMP LX1B/BASS V-AMP PRO LX1B PRO User Manual Effect no. 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 POST FX EFFECTS Controller 40 EFFECTS + TAP button Controller 41 TAP button Controller 46 MIDI 1 Controller 42 MIDI 2 Controller 43 MIDI 3 Controller 44 MIDI 4 Controller 45 VCF + FLANGER DELAY + CHORUS STEREO DELAY DELAY / LOOP REVERB AMBIENCE VOICE BOX ULTRABASS ROTARY CAB.
BASS V-AMP LX1B/BASS V-AMP PRO LX1B PRO User Manual 7.2 Setting up the “a” reference tone 6.3.3 Special effects VCF+FLANGER: The combination of filter and flanger effect. VOICE BOX: This vocal simulation fades between various vowels (a/e, a/i, a/o etc.) by using a LFO (Low-Frequency Oscillator). You can control this effect via a MIDI foot controller. ULTRABASS: A very low bass sound that lies an entire octave beneath the lowest bass frequency present in the mix is currently very popular.
BASS V-AMP LX1B/BASS V-AMP PRO LX1B PRO User Manual 8.3 Audio connections The input of the BEHRINGER BASS V-AMP/BASS V-AMP PRO is laid out as a mono 1/4" TS connector. Line Out, Aux In as well as headphones output are laid out as stereo 1/4" TRS connectors. Line outputs can be connected to both balanced and unbalanced jacks. The DI OUT connectors of the BASS V-AMP PRO are available as balanced XLR connectors. Digital outputs are available as a cinch connector (S/PDIF) and XLR connector (AES/EBU).
BASS V-AMP LX1B/BASS V-AMP PRO LX1B PRO User Manual 8.5 AES/EBU and S/PDIF standards In general, there are two different standards when the subject is digital signal processing. AES/EBU is the professional, balanced connection with XLR jack connectors. This interface is based on two identical protocols published in November 1985 by the European Broadcast Union (EBU Tech. 3250-E) and in December 1985 by the Audio Engineering Society (AES3-1985).
BASS V-AMP LX1B/BASS V-AMP PRO LX1B PRO User Manual Dimensions/Weight Digital Outputs Dimensions (H x W x D) 2 1/2 x 9 1/4 x 7 1/8" 63 x 236 x 180 mm Weight approx. 4.4 lbs / approx. 2 kg XLR Output impedance 110 Ω Nom. output level 3.5 V peak-to-peak RCA BASS V-AMP PRO Audio Inputs Instrument Input 1/4" TS connector, unbalanced Input impedance 1 MΩ Max. input level +3 dBu Pre DSP Return Line In 1/4" TS connector, unbalanced Input impedance 45 kΩ Max.
BASS V-AMP LX1B/BASS V-AMP PRO LX1B PRO User Manual Power Supply Mains Voltage USA/Canada 120 V~, 60 Hz Europe/U.K./Australia 230 V~, 50 Hz Japan 100 V~, 50 - 60 Hz China/Korea 220 V~, 50Hz General export model 120/230 V~, 50 - 60 Hz Power consumption 15 W Fuse 100 - 120 V~: T 400 mA H 200 - 240 V~: T 200 mA H Mains connection Standard IEC receptacle Dimensions/Weight Dimensions (H x W x D) 3 1/2 x 19 x 5 1/4" 89 x 482.6 x 135 mm Weight approx. 6.1 lbs / approx. 2.
BASS V-AMP LX1B/BASS V-AMP PRO LX1B PRO User Manual 10.
BASS V-AMP LX1B/BASS V-AMP PRO LX1B PRO User Manual Function Transmitted Received Remarks 60 N Y (if FX=Delay/Loop) Sampler PLAY ONCE *8 61 N (request only) Y Amp Type (0-32) w/o cabinet change 64 N Y Tap (Value > 63) 80 N Y Request Controls (Value = 80) 81 N (request only) Y Set Pos (0-15), Set Character (32-127) 82 Y Y Tuner Bypass Volume (0-127) 83 Y Y Tuner Center Frequency (25-55) 84 Y Y Configuration (0-5=S1,S2,S3,L1,L2,L3) 85 Y Y Live EQ Treble (0-127) 86
BASS V-AMP LX1B/BASS V-AMP PRO LX1B PRO User Manual FEDERAL COMMUNICATIONS COMMISSION COMPLIANCE INFORMATION BASS V-AMP LX1B/ BASS V-AMP PRO LX1B PRO Responsible Party Name: MUSIC Group Services US Inc. Address: 18912 North Creek Parkway, Suite 200 Bothell, WA 98011, USA Phone/Fax No.
We Hear You