MINIAMP GMA100 User Guide Version 1.
MINIMAMP GMA100 IMPORTANT SAFETY INSTRUCTIONS: 1) 2) 3) 4) 5) 6) 7) Read these instructions. Keep these instructions. Heed all warnings. Follow all instructions. Do not use this apparatus near water. Clean only with dry cloth. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions. 8) Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.
MINIAMP GMA100 The MINIAMP GMA100 is a compact but powerful guitar amplifier. With this unit, you can adjust not only the volume of your electric guitar, but also the tone and level of distortion. And you can play privately—the GMA100 includes a headphone connector. For your convenience, the GMA100 can run on mains power (via a DC 9 V power adapter) or a 9 V battery. 1.1 Before you start 1.1.1 Shipment Your GMA100 was carefully packed at the factory.
MINIMAMP GMA100 1.1.3 Online registration Please do remember to register your new BEHRINGER equipment right after your purchase by visiting www.behringer.com (alternatively www.behringer.de) and kindly read the terms and conditions of our warranty carefully. Should your BEHRINGER product malfunction, our goal is to have it repaired as quickly as possible. To arrange for warranty service, please contact the retailer from whom the equipment was purchased.
MINIAMP GMA100 modify a guitar signal V monitor the status of the GMA100 (on or off) DEUTSCH V Fig. 2.1: The top of the GMA100 Before you connect a guitar to the GMA100 ( control to the minimum setting. ), turn the VOLUME ( ) GAIN control: To adjust the amount of signal distortion, turn this knob toward min (zero, no distortion) or, alternatively max (maximum distortion).
MINIMAMP GMA100 2.2 Connectors This section illustrates and provides descriptions of what you need to connect the GMA100 to: V an electric guitar V headphones V mains power Fig 2.2: The side of the GMA100 PHONES connector: To connect headphones to the GMA100 and mute the loudspeaker, use this 1/8" stereo connector. High volume levels can overload headphones speakers, which create distortion. If this happens, reduce the VOLUME setting ( ).
MINIAMP GMA100 DC 9 V connector: You can also power the GMA100 via a 9 V battery. For details, see 2.3 Battery Compartment and Accessories. 2.3 Battery compartment and accessories This section illustrates and provides descriptions of the setup accessories and battery compartment. Fig. 2.3: The rear of the GMA100 Belt Clip: To hang the GMA100 from your belt or a wall fixture, use this hook. Stand: When you set the GMA100 on a table or floor, pull out this stand.
MINIMAMP GMA100 2.4 Serial number The serial number that uniquely identifies your GMA100 is located on the bottom of the unit. You need this number to register your GMA100. In most countries, register online at www.behringer.com. In Japan, fill out the warranty card that comes with your unit. 3. BASIC SETTINGS The sounds that you create with the GMA100 depend on your playing style and guitar. To find the sounds you want, experiment with the GMA100.
INPUT Type Impedance 1/4" TS connector (mono) approx. 500 kΩ PHONES Type Impedance Max. output level 1/8" stereo connector min. 32 Ω 85 mW LOUDSPEAKER Size Impedance Power rating 3" (approx. 76 mm) 4Ω 5W POWER Power amp output Power supply Mains voltages USA/Canada China/Korea U.K./Australia Europe Japan Power consumption DIMENSIONS/WEIGHT Dimensions (H x W x D) Weight DEUTSCH MINIAMP GMA100 4. SPECIFICATIONS 2 W @ 4 Ω load - External power supply: 9 V / min.
MINIMAMP GMA100 5. WARRANTY § 1 OTHER WARRANTY RIGHTS AND NATIONAL LAW 1. This warranty does not exclude or limit the buyer’s statutory rights provided by national law, in particular, any such rights against the seller that arise from a legally effective purchase contract. 2. The warranty regulations mentioned herein are applicable unless they constitute an infringement of national warranty law.
MINIAMP GMA100 description of the problem. BEHRINGER will then issue a return authorization number. 3. Shipments without freight prepaid will not be accepted. § 5 WARRANTY REGULATIONS 1. Warranty services will be furnished only if the product is accompanied by a copy of the original retail dealer’s invoice. Any product deemed eligible for repair or replacement under the terms of this warranty will be repaired or replaced. 2.
MINIMAMP GMA100 6. If an inspection of the product by BEHRINGER shows that the defect in question is not covered by the warranty, the inspection costs are payable by the customer. 7. Products which do not meet the terms of this warranty will be repaired exclusively at the buyer’s expense. BEHRINGER will inform the buyer of any such circumstance. If the buyer fails to submit a written repair order within 6 weeks after notification, BEHRINGER will return the unit C.O.D.