PMP860M/PMP880S/PMP1280S EUROPOWER User manual Version 1.
EUROPOWER PMP860M/PMP880S/PMP1280S IMPORTANT SAFETY INSTRUCTIONS 12) Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnect device shall remain readily operable. 13) Only use attachments/accessories specified by the manufacturer. 14) Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over.
EUROPOWER PMP860M/PMP880S/PMP1280S FOREWORD Dear Customer, Welcome to the team of EUROPOWER users and thank you very much for expressing your confidence in BEHRINGER products by purchasing this power mixer.
EUROPOWER PMP860M/PMP880S/PMP1280S 1.1.2 Initial operation 1. INTRODUCTION Congratulations! With the PMP mixer you have acquired a stateof-the-art power mixer that sets new standards. Right from the very start it has been our goal to design a revolutionary unit that can be used for a wide variety of applications. And indeed, this overwhelming power mixer gives you plenty of functionality and a broad range of connection and expansion options.
EUROPOWER PMP860M/PMP880S/PMP1280S 2.2 Effects section 2. CONTROL ELEMENTS A detailed description of all functions of your power mixer can be found in the following chapters. Please also refer to the enclosed sheet with the numbered illustrations to get an overview of the control layout. 2.1 Mono and stereo channels + LED level meter of the effects processor. Since the PMP880S/PMP1280S allows you to select two effects simultaneously, it also has two level meters (DUAL FX).
EUROPOWER PMP860M/PMP880S/PMP1280S The PMP860M also has three operating modes, since it can be operated in two modes with the switch in its upper position (MAIN/MAIN (BRIDGE) mode), depending on the pin connections of the speaker cables. In MAIN/MAIN (BRIDGE) mode power of both outputs is added and provided at OUTPUT B (Speakon cable, pins 1+/2+). With the normal pin connections (Speakon cable, pins 1+/1-) a main signal is provided in this mode at OUTPUT A and B (not bridged).
EUROPOWER PMP860M/PMP880S/PMP1280S in MAIN/MAIN (BRIDGE) mode to take the mono main signal from this output (not bridged). Please also refer to chapter 4.3 Loudspeaker connection. + + + In BRIDGE mode, always connect only one loudspeaker with an impedance of at least 8 W to OUTPUT B (pins 1+/2+)! Please note that OUTPUT A must NEVER be used in BRIDGE mode (with pin connections 1+/2+)! In all other operating modes, the minimum impedance of the speaker connected must not fall below 4 W.
EUROPOWER PMP860M/PMP880S/PMP1280S Fig. 4.5: RCA cable 4.3 Loudspeaker connection Your EUROPOWER is equipped with high-quality Neutrik Speakoncompatible loudspeaker connectors, which ensure safe and trouble-free operation. This connector was especially developed for high-power loudspeakers. Once it is plugged in, it safely locks into position and cannot be accidentally disengaged. It prevents the occurrence of electrical shock and ensures the correct polarity.
EUROPOWER PMP860M/PMP880S/PMP1280S Both the PMP880S/PMP1280S and the PMP860M can be set-up for dual mono operations. The POWER AMP switch must be set to its lower (PMP860M) or center position (PMP880S/PMP1280S). The two loudspeaker outputs provide the main and monitor signals independently of each other and to two loudspeakers each, which are wired in parallel. One example of how to use your power mixer with a subwoofer in bridged mono mode.
EUROPOWER PMP860M/PMP880S/PMP1280S 6. SPECIFICATIONS 0,&523+21( ,13876 303 0 303 6 303 6 XLR, electronically balanced input circuit Type Mic E.I.N. (20 Hz - 20 kHz) @ 0 Ohm source resistance -112 dB / 114 dB A-weighted @ 50 Ohm source resistance -112 dB / 114 dB A-weighted @ 150 Ohm source resistance -112 dB / 114 dB A-weighted < 10 Hz - 200 kHz (-1 dB) Frequency response < 10 Hz - > 200 kHz (-3 dB) +30 dB, +10 dB with pad Gain +12 dBu @ +10 dB gain Max. input level approx. 2.
EUROPOWER PMP860M/PMP880S/PMP1280S 303 0 /28'63($.(5 2873876 303 6 303 6 Neutrik Speakon-compatible connector Type Load impedance: MAIN L/R - MONITOR/MAIN MONO 4 - 8 Ohm 4 - 8 Ohm 4 - 8 Ohm MAIN MONO/MAIN MONO 4 - 8 Ohm BRIDGE 8 - 16 Ohm Converter 24-bit Delta-Sigma, 64/128-times oversampling '63 Dynamics D/A 90 dB Sampling rate 40 kHz max. 5 secs Delay Time approx. 1.
EUROPOWER PMP860M/PMP880S/PMP1280S 7. WARRANTY § 1 OTHER WARRANTY RIGHTS AND NATIONAL LAW 1. This warranty does not exclude or limit the buyers statutory rights provided by national law, in particular, any such rights against the seller that arise from a legally effective purchase contract. 2. The warranty regulations mentioned herein are applicable unless they constitute an infringement of national warranty law. 2.
EUROPOWER PMP860M/PMP880S/PMP1280S FEDERAL COMMUNICATIONS COMMISSION COMPLIANCE INFORMATION Responsible party name: BEHRINGER USA, Inc. Address: 18912 North Creek Parkway, Suite 200 Bothell, WA 98011, USA Phone/Fax No.
