Manual

ManualsBrandsBehringer ManualsIn-Line Problem SolversUltra-Compact Phantom Power Supply

MICROPOWER PS400

Welcome to BEHRINGER

Thank you for showing your con dence in us by purchasing the BEHRINGER MICROPOWER

PS400. Use this ultra-compact phantom power supply with mixers and microphone

preampli ers that do not include phantom power sources. The PS400:

• supplies phantom power (+12 V or +48 V) to any type of condenser microphone

• routes the microphone signal to a mixer or a microphone preampli er

◊ Please read the safety instructions that appear at the end of this document.

Connectors and Control Elements

This section illustrates and describes each PS400 connector and control element.

(2)

(1) (3) (4) (5)

Fig. 1: PS400 connectors and control elements

(1) 12 V connector:

To connect the power supply unit to the PS400, use the 12 V connector. Connecting the

power supply unit to the mains automatically switches the PS400 on. To disconnect

the unit from the mains, pull out the main cord plug.

(2) ON LED:

As soon as the unit is connected to the mains, the ON LED is illuminated.

(3) MIC INPUT connector:

To send a microphone signal to the PS400, you need an audio cable that includes XLR

connectors. Plug:

• one XLR connector into the MIC INPUT connector

• the other XLR connector into the condenser microphone

(4) MIC THRU connector:

To route the microphone signal from the PS400 to a mixer or a microphone

preampli er, you need an audio cable that includes XLR connectors. Plug:

• one XLR connector into the MIC THRU connector

• the other XLR connector into the mic input of a mixer or, alternatively a

microphone preampli er

(5) +12 V / +48 V PHANTOM VOLTAGE switch:

To select the voltage that you need, push this switch toward +12 V or, alternatively

+48 V. For details about what value to use, refer to instructions from the

microphone manufacturer.

SERIAL NUMBER: To register the unit, use the serial number that is located on the bottom

of the PS400.

Setup Example

The following is an example of how to set up the PS400:

MICROPOWER PS400

PROMIXER DJX750

STUDIO CONDENSER

MICROPHONE C-1

MIC THRU

MIC INPUT

Fig. 2: PS400 setup example

Warranty

For the applicable warranty terms and conditions and additional information

regarding MUSIC Group’s Limited Warranty, please see complete details online at

www.music-group.com/warranty.

Summary of content (2 pages)

PAGE 1
MICROPOWER PS400 (5) +12 V / +48 V PHANTOM VOLTAGE switch: Welcome to BEHRINGER Thank you for showing your confidence in us by purchasing the BEHRINGER MICROPOWER PS400. Use this ultra-compact phantom power supply with mixers and microphone preamplifiers that do not include phantom power sources.
PAGE 2
MICROPOWER PS400 Specifications Instrucciones de seguridad Mic Input and Mic Thru Type XLR connector balanced Phantom Power Supply Voltage (switchable) +12 V or +48 V Power Supply Mains connector external power supply, 12 V𝌂 / 150 mA 1) Lea las instrucciones. 2) Conserve estas instrucciones. 3) Preste atención a todas las advertencias. 4) Siga todas las instrucciones. 5) No use este aparato cerca del agua. 6) Limpie este aparato con un paño seco. 7) No instale el equipo cerca de fuentes de calor.