User Manual STUDIO CONDENSER MICROPHONE Studio Condenser Microphone
STUDIO CONDENSER MICROPHONE C-1 User Manual Important Safety Instructions After each use, wipe the microphone down with a soft cloth and place it back into its protective casing (included with the microphone). The small bag containing the moisture-absorbing crystals should remain in the casing to help keep your microphone dry. Terminals marked with this symbol carry electrical current of sufficient magnitude to constitute risk of electric shock.
STUDIO CONDENSER MICROPHONE C-1 User Manual 1. Power Supply Your condenser mic C-1 needs a phantom power supply (+36 to +52 V). If your C-1 is connected to a microphone preamp and supplied with phantom power, the LED on the microphone lights up. Behringer assumes no liability for any damage caused by a defective phantom power supply. Always mute the sound reinforcement system before you switch on the phantom power supply. 2.
STUDIO CONDENSER MICROPHONE C-1 User Manual If necessary, you can bend the microphone out of its vertical position by using the hinge on the microphone stand. ◊ Please make sure to handle the microphone shaft with attention and care to avoid damaging the screw thread. In no situation should you ever apply excessive force. Of course, you can detach the C-1 from the stand mount adapter and attach it to a commercially available suspension mount. 4.
STUDIO CONDENSER MICROPHONE C-1 User Manual 340° 0° 0 dB 20° -5 dB 320° 40° -10 dB -15 dB 300° 60° -20 dB -25 dB -30 dB 280° 80° -35 dB -40 dB 260° 100° 240° 120° 140° 220° 200° 180° 160° 1kHz Polar pattern dB 20.0 10.0 0.0 -10.0 -20.0 20.0 Frequency response 100.0 1000.
STUDIO CONDENSER MICROPHONE C-1 User Manual 6. Specifications Transducer type condenser, 16 mm Polar pattern cardioid Connection: gold-plated balanced XLR connector Open circuit sensitivity -33 ± 2 dBV (0 dBV = 1 V/Pa) Frequency response 40 Hz - 20 kHz Max. SPL (1% THD @ 1 kHz) 136 dB Nominal impedance 100 Ω Load impedance >1 kΩ Mains Voltage / Fuse Supply voltage +36 - 52 V Supply current 2.5 mA Physical/Weight Dimensions Ø shaft: 54 mm length: 169 mm Weight approx. 0.