User Manual EURORACK UB1202/UB1002 Ultra-Low Noise Design 12/10-Input 2-Bus Mic/Line Mixer UB802/UB502 Ultra-Low Noise Design 8/5-Input 2-Bus Mixer
EURORACK UB1202/UB1002/UB802/UB502 User Manual Table of Contents Important Safety Instructions....................................... 3 Legal Disclaimer.............................................................. 3 Limited Warranty............................................................ 3 1. Introduction................................................................ 5 1.1 General mixing console functions................................. 5 1.2 The user’s manual.....................................
EURORACK UB1202/UB1002/UB802/UB502 User Manual Important Safety Instructions Terminals marked with this symbol carry electrical current of sufficient magnitude to constitute risk of electric shock. Use only high-quality professional speaker cables with ¼" TS or twist-locking plugs pre-installed. All other installation or modification should be performed only by qualified personnel.
EURORACK UB1202/UB1002/UB802/UB502 User Manual “Support” at behringer.com. If your country is not listed, please check if your problem can be dealt with by our “Online Support” which may also be found under “Support” at behringer.com. Alternatively, please submit an online warranty claim at behringer.com BEFORE returning the product. All inquiries must be accompanied by a description of the problem and the serial number of the product.
EURORACK UB1202/UB1002/UB802/UB502 User Manual 1. Introduction Congratulations! In purchasing our EURORACK UB502/UB802/UB1002/UB1202 you have acquired a mixing console whose small size belies its incredible versatility and audio performance. The range of inputs and outputs comprises microphone inputs (with +48 V phantom power supply), line inputs, possibilities for connecting effects devices, connectors for a 2-track master machine (e.g.
EURORACK UB1202/UB1002/UB802/UB502 User Manual 2. Control Elements and Connectors This chapter describes the various control elements of your mixing console. All controls, switches and connectors will be discussed in detail. 2.1 Mono channels 2.1.1 Microphone and line inputs EQ The upper (HI) and the lower band (LO) are shelving filters that increase or decrease all frequencies above or below their cut-off frequency.
EURORACK UB1202/UB1002/UB802/UB502 User Manual 2.2 Stereo channels 2.2.1 Stereo line inputs BAL The BAL(ANCE) control determines the levels of left and right input signals relative to each other before both signals are then routed to the main stereo mix bus. If a channel is operated in mono via the left line input, this control has the same function as the PAN control used in the mono channels. LEVEL Fig. 2.
EURORACK UB1202/UB1002/UB802/UB502 User Manual 2.3.2 Monitor and main mix Alternatively the line or tape output of a hi-fi amplifier with source selection switch could also be hooked up here, allowing you to easily listen to additional sources. TAPE OUTPUT These connectors are wired in parallel with the MAIN OUT and carry the main mix signal (unbalanced). Connect the TAPE OUTPUT to the inputs of your recording device.
EURORACK UB1202/UB1002/UB802/UB502 User Manual +48 V 3.2 Audio connections The red +48 V LED lights up when phantom power is on. The PHANTOM switch activates the phantom power supply on the XLR connectors of all mono channels. You will need a large number of cables for different applications. The illustrations below show how the connectors should be wired. Be sure to use only high-grade cables.
EURORACK UB1202/UB1002/UB802/UB502 User Manual Balanced ¼" TRS connector 4. Specifications strain relief clamp Mono Inputs sleeve ring tip Microphone Inputs (IMP “Invisible” Mic Preamp) Type sleeve ground/shield ring cold (-ve) tip hot (+ve) For connection of balanced and unbalanced plugs, ring and sleeve have to be bridged at the stereo plug. Fig. 3.
EURORACK UB1202/UB1002/UB802/UB502 User Manual Equalizer Power Supply EQ Mono Channels Power Consumption LOW 80 Hz / ±15 dB UB1202: 23 W MID 2.5 kHz / ±15 dB UB1002: 18 W HIGH 12 kHz / ±15 dB UB802: 17 W UB502: 13 W EQ Stereo Channels LOW 80 Hz / ±15 dB MID 2.5 kHz / ±15 dB USA/Canada 120 V~, 60 Hz, MXUL5 adapter HIGH 12 kHz / ±15 dB U.K.
We Hear You