ULTRA-DI DI100 User Manual User Manual ULTRA-DI DI100 Professional Battery/Phantom Powered DI-Box
ULTRA-DI DI100 User Manual Table of Contents Thank you.................................................................................. 2 1. Control Elements.................................................................. 7 2. DI100 Configurations........................................................... 8 2.1 Tapping signal from the (Bass) guitar....................................... 8 2.2 Converting the output of a Keyboard / DJ-mixer / Headphone plug..............................................
ULTRA-DI DI100 User Manual Important Safety Instructions Terminals marked with this symbol carry electrical current of sufficient magnitude to constitute risk of electric shock. Use only high-quality professional speaker cables with ¼" TS or twist-locking plugs pre-installed. All other installation or modification should be performed only by qualified personnel.
ULTRA-DI DI100 User Manual 9. Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the other. A grounding-type plug has two blades and a third grounding prong. The wide blade or the third prong are provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet. 10.
ULTRA-DI DI100 User Manual TRANSMITTED IN ANY FORM OR BY ANY MEANS, ELECTRONIC OR MECHANICAL, INCLUDING PHOTOCOPYING AND RECORDING OF ANY KIND, FOR ANY PURPOSE, WITHOUT THE EXPRESS WRITTEN PERMISSION OF MUSIC GROUP IP LTD. ALL RIGHTS RESERVED. © 2013 MUSIC GROUP IP LTD. TRIDENT CHAMBERS, WICKHAMS CAY, P.O.
ULTRA-DI DI100 User Manual Welcome to BEHRINGER! DI stands for Direct Injection. On stage or in the studio there are sources you want to connect to your mixer that are not equipped with a suitable connection. Keyboards seldom have properly balanced outputs. Guitars cannot be directly plugged into a mixer and placing a microphone in front of a backline is not always ideal. A microphone picks up ambient noise such as other instruments.
ULTRA-DI DI100 User Manual ◊ To avoid switching noise, you should mute the desk channel before activating the DI100. Same applies when switching between battery and phantom power and vice versa. The design of the DI100 includes four sturdy rubber feet which protect the unit (even during a unplanned drop) and allow cables to run underneath. It also provides literally a “ground lift” so that the unit can be stacked on top of another unit and other equipment without creating ground loops. 1.
ULTRA-DI DI100 User Manual ◊ Only use the -20 dB switches if you are sure the ULTRA-DI is clipping (overloading) and not your mic pre-amp. Always use as little attenuation as possible to get the best possible signal-to-noise ratio. (6) OUTPUT. This is the balanced microphone level output of the ULTRA-DI. Connection to the microphone input should be made with a standard high quality balanced cable.
ULTRA-DI DI100 User Manual This figure shows the standard application of any direct injection box. The signal to the amplifier is unaffected, it is just tapped off to be routed to the microphone input of the mixer. Especially bass guitars benefit from this application. It is difficult to find a microphone which handles high level low frequencies well and with a linear frequency response. Using the ULTRA-DI will give you clean and crisp sound.
ULTRA-DI DI100 User Manual 2.3 Converting a microphone from high impedance unbalanced to low impedance balanced Sometimes all that’s available (especially when all other mics are in use) is a unbalanced high impedance microphone with an unbalanced jack. With the ULTRA-DI long cable runs to the console can be established without fear of picking up noise and hum. Just plug the jack into the input and connect the output to the console’s mic in. 2.
ULTRA-DI DI100 User Manual 3. Specifications Frequency Response 10 Hz to 93 kHz Noise Level -110 dBu THD + N @ 1 kHz / 0 dBu < 0,005 % Input Impedance > 250 kOhm Load Impedance > 600 Ohm Inputs 1/4" jack unbal. In/Link Out XLR unbalanced In Output XLR balanced Out Maximum Input level +10/ +30/ +50 dBu Power supply Phantom power 18 V DC to 48 V DC Battery 9 V blockcell 6LR91 Dimensions 150 x 130 x 60 mm Weight ca.
We Hear You