User Manual U-CONTROL UCA202 Ultra low-latency 2 In/2 Out USB/Audio Interface with Digital Output behringer.
U-CONTROL UCA202 User Manual Table of Contents Thank you Thank you......................................................................2 Important Safety Instructions....................................3 Legal Disclaimer...........................................................4 Limited Warranty..........................................................4 1. Introduction.............................................................8 1.1 Before you started................................................
U-CONTROL UCA202 User Manual Important Safety Instructions Terminals marked with this symbol carry electrical current of sufficient magnitude to constitute risk of electric shock. Use only high-quality commercially-available speaker cables with ¼" TS plugs pre-installed. All other installation or modification should be performed only by qualified personnel.
U-CONTROL UCA202 User Manual 11. Use only attachments/accessories specified by the manufacturer. 12. Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over. 13. Unplug this apparatus during lightning storms or when unused for long periods of time. 14. Refer all servicing to qualified service personnel.
U-CONTROL UCA202 User Manual product shows any defects within the specified warranty period and that defect is not excluded under § 4, MUSIC Group shall, at its discretion, either replace or repair the product using suitable new or reconditioned product or parts. In case MUSIC Group decides to replace the entire product, this limited warranty shall apply to the replacement product for the remaining initial warranty period, i.e.
U-CONTROL UCA202 User Manual manufactured, this modification/adaptation shall not be considered a defect in materials or workmanship. This limited warranty does not cover any such modification/adaptation, regardless of whether it was carried out properly or not. Under the terms of this limited warranty, MUSIC Group shall not be held responsible for any cost resulting from such a modification/adaptation. [3] This limited warranty covers only the product hardware.
U-CONTROL UCA202 User Manual § 6 Claim for damage Subject only to the operation of mandatory applicable local laws, MUSIC Group shall have no liability to the buyer under this warranty for any consequential or indirect loss or damage of any kind. In no event shall the liability of MUSIC Group under this limited warranty exceed the invoiced value of the product. § 7 Limitation of liability This limited warranty is the complete and exclusive warranty between you and MUSIC Group.
U-CONTROL UCA202 User Manual 1. Introduction The UCA202 is PC and Mac-compatible. Therefore, no separate installation procedure is required, while the operating system drivers ensure an extremely short latency. Thanks to its robust construction and compact dimensions, the UCA202 is also ideal for traveling. The separate headphones output allows you to play back your recordings at any time, even if you don’t happen to have any loudspeakers available.
U-CONTROL UCA202 User Manual ◊ Please dispose of all packaging materials in an environmentally friendly fashion. 1.1.2 Initial operation Please make sure the unit is provided with sufficient ventilation, and never place the UCA202 on top of an amplifier or in the vicinity of a heater to avoid the risk of overheating. The current supply is made via the USB connecting cable, so that there is no external power supply unit required. All required safety precautions have been adhered to. 1.1.
U-CONTROL UCA202 User Manual 2. System Requirements ◊ The UCA202 is PC and Mac-compatible. Therefore, no installation procedure or drivers are required for the correct functioning of the UCA202. To work with the UCA202, your computer must fulfill the following ninimum requirements: PC Intel or AMD CPU, 1 GHz or higher minimum 512 MB RAM USB 2.0 interface Windows XP SP2 MAC 3. Operating Elements and Connections 3.1 Front panel [1] LED G4/G5, 800 MHz or higher minimum 512 MB RAM USB 2.
U-CONTROL UCA202 User Manual Use the jack to connect a standard pair of headphones equipped with a 1/8" TRS connector. Use the LINE-OUT jacks for audio cables with RCA connectors. The VOLUME control adjusts the volume level of the headphones output. Turn the control fully to the left before you connect the headphones. This helps you avoid the damage that is caused by high volume settings. Use the LINE-IN jacks for audio cables with RCA connectors. 3.2 Rear panel [5] Fig. 3.
U-CONTROL UCA202 User Manual 4. Working with the UCA202 4.1 Application example TRUTH B2031A XENYX1204FX U-CONTROL UCA202 Laptop Fig. 4.1: Common version with the UCA202 behringer.
U-CONTROL UCA202 User Manual To provide a professional recording interface between mixing console and computer, you can use the UCA202 in combination with a suitable mixing console that includes subgroup outputs. This type of setup allows you to record several signals in the computer at the same time, to simultaneously play back several takes or playbacks which have been recorded, and to listen to the whole recording via loudspeakers (or headphones). Figure 4.1 shows a possible setup with one UCA202.
U-CONTROL UCA202 User Manual 5. Audio Connections Although there are various ways to integrate the UCA202 into your studio or live set-up, the audio connections to be made will basically be the same in all cases: Sleeve Tip Sleeve Tip 5.1 Wiring Fig. 5.2: Adapter cable with ¼" jack Please use standard RCA cables to connect the UCA202 to other audio equipment. You can also use an adapter cable. 5.2 Headphones connection tip tip sleeve Fig. 5.1: RCA cable behringer.
U-CONTROL UCA202 User Manual 6. Specifications LINE IN USB 1.1 Connectors RCA, unbalanced Input impedance approx. 27 kΩ Max. input level 2 dBV LINE OUT Connectors RCA, unbalanced Output impedance approx. 400 Ω Max. output level 2 dBV Connectors Digital Processing Converter 16-bit converter Sample rate 32.0 kHz, 44.1 kHz, 48.0 kHz System Data Frequency response 10 Hz to 20 kHz, ± 1 dB @ 44.1 kHz sample rate 10 Hz to 22 kHz, ± 1 dB @ 48.0 kHz sample rate THD 0.05 % typ.
U-CONTROL UCA202 User Manual Power Supply USB connection 5V , 100 mA max. Dimensions/Weight Dimensions (H x W x D) approx. 0.87 x 3.46 x 2.36" approx. 22 x 88 x 60 mm Weight approx. 0.12 kg BEHRINGER always takes great care to ensure the highest standard of quality. Any modifications which may be necessary will be made without prior notification. Specifications and appearance of the equipment can therefore differ from the details or illustrations shown. behringer.
U-CONTROL UCA202 User Manual FEDERAL COMMUNICATIONS COMMISSION COMPLIANCE INFORMATION U-CONTROL UCA202 Responsible party name: MUSIC Group Services USA, Inc. Address: 18912 North Creek Parkway, Suite 200 Bothell, WA 98011, USA Phone/Fax No.
behringer.